Search results

  1. NO_RICE

    Help me decide what to do with this thing

    I have been getting the urge to sell my 94 gt and get back into a foxbody. I have never really enjoyed driving the SN95 as much as I did the fox, it always seemed slower and like a boat in the handling department. Well then I decided that I would put a turbo on it and that would fix...
  2. NO_RICE

    New motor mounts, and resonance

    I just replaced the mounts in my 94 GT with energy suspension mounts. while I was at it I sealed up an exhuast leak that I have had since I installed the turbo. Now there is a really low drone at around idle, its like a 40hz frequency, it sounds almost like a subwoofer, even though the stereo...
  3. NO_RICE

    LCA install problems

    I am installing LCAs in my 94 GT. I took the sway bar off and got the rear bolt half way out of the control arm when the axle shifted toward the back of the car and now I can't get the bolt out. There doesn't seem to be anything to pry on, and I can't get a punch into the hole to pry it into...
  4. NO_RICE

    Turbo on - No oil pressure??

    I finally got my car started again, the problem is that my oil pressure gauge reads below 0 when the car is off and jumps just slightly over zero when the car is started. I have tried several things so far: - double checked the lines on my oil filter relocation kit - disconnected the...
  5. NO_RICE

    help me repair my smog tube (picture)

    While attempting to move the check valve on my smog tube it litterally broke off in my hand (its rusted on the inside), now I need to reattach it, but I want to use a piece of rubber hose. has anyone done this, is there any reason it wouldn't work? It connects to a rubber hose after the valve...
  6. NO_RICE

    94-95 GT throttle cable the same as cobra??

    94-95 GT cruise control cable the same as cobra?? Just what the titles says, will a GT cruise control cable bolt up to a cobra (94-95), I am selling one on ebay and the questions arose, I just want to be sure, don't want to steer anyone wrong.
  7. NO_RICE

    emissions question

    Has anyone ever used an electric smog pump in place of a belt driven smog pump and passed the visual inspection at emissions? I can't find much information on electric smog pumps, I know they came on the SN95 Cobras, however I am not able to find a picture of the unit or how it mounted. I...
  8. NO_RICE

    FOX TB CONVERSION EGR HELP

    I am doing the fox TB conversion, and I want to run the cooling lines through the EGR plate, the problem is I can't remember where the lines connected to on my fox, does anyone have pictures of how the lines connect?
  9. NO_RICE

    Remove A/C?

    Well I finally got a daily driver and now it is time to start on the turbo project for the mustang. I can't decide if I should remove the A/C or not. I think I can deal with a car not having A/C, but if I decide to sell it how hard is it going to be to put the AC back on?
  10. NO_RICE

    HELP I THINK I GOT RIPPED OFF

    I purchased a transmission on ebay and when I recieved it today the casting number on it is not the same as what is stated in the auction. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=8032167126 the number on the case is 13-52-065-921 I looked this up and it is out of...
  11. NO_RICE

    Strange transmission question

    I have a tremec 3550 in my car at the moment (94GT), my car is a daily driver and I am sick of the noise typical of the tremecs. I would like to replace it with something less heavy duty at the moment. however I have a few questions: 1) will a 87-93 t5 bolt directly in the place of the...
  12. NO_RICE

    Im getting pissed...need help with idle

    I swapped the throttle body and the upper intake, and when I did this the idle completely went to crap. Now it idles at 1000 rpm on a good day, half the time it will idle at 1200-1300 rpm when I come to a stop, half the time it will idle normal. I usually wont have the hanging idle problem...
  13. NO_RICE

    x pipe welded

    My bissani x pipe has been welded together for some stupid reason. Not only is it hard to get off and on but it is also hangs really low and there is nothing I can do about it. So my question is can I legally have my cats clamped onto my exhuast or was that the reason they were welded? If so...
  14. NO_RICE

    what type of refrigerant

    This is kind of a dumb question, but what kind of refrigerant does my car need (94 gt) R134 or R12?
  15. NO_RICE

    New to Phoenix area

    I am new to the valley, moved here a couple of months ago from Tucson, just wondering what you guys do on your spare time around here.
  16. NO_RICE

    window motor help

    My passenger window rolls up really slowly, does anyone make a rebuild kit for the motor. If it needs to be replaced, where is the cheapest place to get a new one.
  17. NO_RICE

    factory distributor: cast iron or steel gear??

    I need to know if the factory distributor came with a cast iron or steel gear. I can't find information on this anywhere.
  18. NO_RICE

    performance distributor worth the $$

    I recently noticed that my rotor is making physical contact with the contacts on my distributor cap. I need to replace the distributor, but was wondering if a stock replacement was the way to go or if I should upgrade. Also did the factory distributor come with steel or cast iron gears and can...
  19. NO_RICE

    Got my car broken into, HELP!

    Will a side window out of an 83 hatch fit in a 90 hatch? I tried to make it fit but it does not want to go all the way up, it almost looks right, Im not so sure that it is the right window though, but it was free. If anyone knows one way or another FOR A FACT that would definately save me some...
  20. NO_RICE

    Pistons for S/C application

    I need to rebuild my motor, but the rebuild kit from summit with the forged pistons is 10.13:1 compression, I also want to put a supercharger on it this summer, so I was hoping that someone could suggest a good kit with forged pistons that would work for me, or I could buy the hypereutectic kit...
Top Bottom
Back
Forums
Menu