Search results

  1. harrellv10

    Spark plugs fouling/backfiring... need tuning help?

    I keep having to replace the plugs in my 1994 GT. It runs fine when the plugs are fresh, but after a month or two it starts backfiring, sputtering when taking off from a stop light, and smelling like fuel. The plugs that come out then are looking black and soot-covered. I just thought it was...
  2. harrellv10

    Trick Flow Rocker Stud Girdles For Sale

    I am selling a new, never installed set of Trick Flow rocker stud girdles for 5.0 engines with 7/16" studs. These are about $125 new from summit racing. I am asking $40 plus shipping. Requires tall valve covers. Part number is TFS-51400701. Email or call or text John at 501-551-1192 with...
  3. harrellv10

    Borla Universal Turbo Mufflers For Sale

    I had these mufflers on my 1994 mustang GT, with a supercharged 347. With JBA 1.75" shorties, a 2.5" MAC Prochamber H-pipe, and these mufflers, the setup made over 550 RWHP. They have a deep, mellow rumble sound. Not abnoxious like Flowmaster (which I had before these, but still very...
  4. harrellv10

    High Flow Aluminum Water Pump For Sale

    I am selling my GMB hi-flow aluminum water pump off of my 1994 mustang. I switched to an electric pump, so don't need this one. 300 miles on it. Engine never got warmer than 160 degrees with this baby, a fluidine radiator, and 160 degree thermostat. This was on a supercharged 347 that made...
  5. harrellv10

    Trick Flow Track Heat Intake For Sale

    I am selling a black powder coated Trick Flow Track Heat Intake. It was installed and driven on my 1994 Mustang 347 engine for 300 miles before I switched to the R-Series intake. The intake comes with upper and lower manifolds, a 3/8" phenolic spacer, and gaskets and hardware. Part number is...
  6. harrellv10

    Expired Maximum Motorsports Hd Torque Arm And Panhard For Sale

    I bought this Maximum Motorsports Torque Arm and Panhard Bar set for my 1994 Mustang GT from Mustang Depot a while back and never installed it because I would have to have cut my tail pipes off or ran them under the rear axle to get them around the panhard bar. I don't want to do that, so I...
Top Bottom
Back
Forums
Menu