Search results

  1. P

    Escort flywheel

    I spent a few hours researching on 4M.net and I think I have the solution for using the Escort Flywheel in a 2.3 Mustang. Parts needed: Escort GT flywheel ('80's 1.9L) and bolts. Mustang disc,pressure plate. Here's where it gets a little tricky.Throw-out bearing. option1: use the...
  2. P

    T-5 swap

    Quick Q. Will I need to swap the computer on a 91 LX when I pitch the A4LD in favor of a T-5??? thx;P
  3. P

    cut 5.0 springs

    I'm looking for real life experiences,please. I already replaced my rear springs with no apparent change in stance. My front springs of unknown origin are getting soft. I want to know how much to cut to maintain stock height with "new" stock 5.0 front springs. Thanks
  4. P

    Quarter million

    My car just reached 250,000 miles. In celebration of this milestone I gave it a new set of rear control arms. What a difference! The clunks and squirrely rear steer feeling is history! The RCA's came from a 2000GT that had 20K miles when they were pulled. The old one were so worn that they...
  5. P

    Inner tie rod

    Replaced my d/s inner tie rod today. Piece of cake. The roll pin is about 1/4 " long. I drilled it out and broke it loose with a 12" Crescent wrench.The NAPA replacement was tapped for a machine screw instead of a roll pin. $22 and a couple of hours. Removed the sway for access. The old one had...
  6. P

    Nasty yellow h/l's??

    I spent about 15 minutes buffing mine out and they look almost as good as the new ones I put on my daughter's 91!! I used a polishing attachment on my electric drill and some fine polishing compound followed by a coat of wax. Incredible difference,maybe I can see at night now! :D
  7. P

    Rack bushings

    Just replaced my mushy rubber rack bushings with Energy Suspensions urethane bits. Much improved feel!! Only $10.95 and about half an hour! :D
  8. P

    p/s switch

    I'm getting a GT rack and poly bushings to replace my leaky junk. The rack comes with new lines and being from a GT doesn't have the switch on the p/s line. It should bolt up but what do I do with the switch? Cut the wire or connect it ? Leave it in there? THX;P
Top Bottom
Back
Forums
Menu