Search results

  1. 90muustanggt

    Cracks and spot welds coming apart!! HELP Road Race Question

    Torque Box (Crack and spot welds Coming Apart, HELP!!) Road Race Question Ok, so i road race my car frequently and do a thurough checkup before every event. I have an event coming up at summit point the weekend after next. Anyways while i was scraping the tar paper and painting the trunk area...
  2. 90muustanggt

    New K-member and alignment probs...

    Well I finished the engine, everything runs well. I also installed the Hal K-member. I work at a tire shop so i tried to align it the other day. As usual after a suspension install the toe and camber were out and adjusted fine. However, i could not for the life of me get the caster in line...
  3. 90muustanggt

    Supercharger, engine rebuild, & compression ratio

    I just finished my engine rebuild. Its a mild rebuild with gt40p heads and a summit forged rebuild kit. The problem is that summit rates its forged rebuild kit at like 12:1 and the GT40P heads are supposed to raise the sompression ratio more. Can someone explain if the 12:1 ratio is correct...
  4. 90muustanggt

    Quick motor mount shim question.

    Can i put a few washers between the k-member and motor mount to shim the engine or does a company make a plate to taise the engine about 1/2" per sided? It looks like it puts stress on the mounts if i use washers. :shrug:
  5. 90muustanggt

    May have f-ed up my MSD Distributor

    Well today i attemped to press on my new steel gear where i work using the shop press. i drove the pin out and pressed it off. when i looked at the end of the shaft it looked like it was bent a little. not the shaft itself but the tip of the shaft just crooked. did i just mess up my...
Top Bottom
Back
Forums
Menu