Search results

  1. MikeC

    03 Cobra drivetrain into 92 GT...Got a few questions

    I just bought a complete salvaged 03 Cobra and I’m going to do an engine/drive train/ dash/wiring harness/fuel system/brakes swap into my 92 GT. I’ve done some research but still have a few questions. 1) I’ve read that the 03 fuel tank will fit into the Fox. If anyone has done this, how did...
  2. MikeC

    Need to decrease my brake power...

    I have a pieced together M2300K kit on my 92 (Cobra brakes ft and rear). I have a 93 Cobra MC and booster. The brakes have too much power, very little pedal pressure is required to stop the car. I lightly touch the brakes and it stops. I don't want to change the booster to a smaller one because...
  3. MikeC

    Cobra brake install done!!

    I finally got the last parts from Santa yesterday and finished my Cobra brake install today!! Here's a few pics of the install: Gutted PV from a 1981 Mustang: (yes I need to clean the engine compartment) Rear with Steeda Sport springs, Tokico Illumina shocks, Monroe quad shocks...
  4. MikeC

    Are 99 Cobra rims no more?

    I tried to order a set of silver 99 Cobra rims today and was told they have been discontinued by Ford and none are left. Is this right? I really wanted these for my 92, I guess I'll have to settle for 98 Cobra rims.
  5. MikeC

    Rear axle seal

    Does the rear axle seal get tapped in until the back is against the bearing race or just until it's flush with the end of the housing? It's been a while since I pulled them out so I can't remember.
  6. MikeC

    Watch out for this guy!!

    This might not be the right forum but I found this car on ebay and asked the seller a question about it. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&sspagename=ADME%3AL%3ARTQ%3AUS%3A1&viewitem=&item=180052849637 Here is a copy of the what was exchanged: Me - Hi, Any...
  7. MikeC

    Are 1994 to 2004 rear axles shafts the same?

    Anyone know if the rear axles shafts from a 1994 to 1998 Mustang are the same as the 1999 to 2004? Seems like I heard the length is different. Not including IRS Cobras.
  8. MikeC

    Did Turbo Coupe rear-ends come with 4:10s?

    I was at one of the local pick and pull junk yards yesterday. They had a 88 Turbo Coupe with an automatic. I thought these were supposed to be 3:73 gear ratio. For $100 I could pop the whole assembly in my 92 and get the 3:73s I wanted. I pulled the rear cover off to verify condition and to...
  9. MikeC

    Lincoln Mark VII rear axle/brake swap...

    Will the rear differential from an 1989 Lincoln MarkVII LSC 5.0 work in a Fox mustang? The local Pick and Pull has one. The rear disc look pretty large (11" plus). Is this a good swap into my 92? What is the axle flange to flange distance? Is it the same as a Mustang? What about lug bolt...
  10. MikeC

    Codes 85 & 91

    I changed my clutch the other day and now the check engine light comes on after about 5 minutes of driving. It goes off after the engine is turned off and come back on after driving for about 5 minutes. I pulled the codes abd got an 85 and a 91. The table I have lists 85 as canister purge...
  11. MikeC

    Rear main seal

    Do I need to put any sealant on the outside of the new rear main seal or does it go in dry? thanks
  12. MikeC

    Replacing throwout bearing ratainer.

    Along with my clutch, I'm going to replace my worn aluminum TB retainer with a steel one from Summit. Is it as easy as unbolting the old one and bolting on the new one? Or is there more to it than that?
  13. MikeC

    Foglight lens fell off...

    The lens for one of my fog lights fell off. The bulb and housing are still on the car. Is there a glue I can use to re-attach it?
Top Bottom
Back
Forums
Menu