Search results

  1. bigsparky

    "shakey" starts

    This is tough to explain without being in the car, but maybe some of you have experienced this as well. This is a 5spd 5.0 with Steeda FWA and cable. Before you start pointing fingers at my driving skills, I've been driving standard for years and years, so I know what I'm doing. Anyways, when...
  2. bigsparky

    What is it??

    There was a beeping coming from my dash so I pulled out my HVAC controls and there was this blue box behind it. The beeping was coming from there. So I unplugged it and it didn't seem to affect anything... what is this box for?? It's got quite a few wires going into it (8-12ish)
  3. bigsparky

    Headlight problem please help!

    I'll try to give as much information as possible: My headlights don't turn on. I have a 92 so it has daytime running lights. The DRL's DO turn on. When I push the headlight switch to the first position, all the corner lights, rear lights, etc come on that are supposed to come on, and the...
  4. bigsparky

    Code 96 fuel pump circuit?

    I just scanned my codes on my 92 GT and I got a code 96. In the haynes manual it says "fuel pump circuit". What would the problem be???
  5. bigsparky

    stripped bolt for water pump HELP PLEASE!!!

    I replaced my water pump and ever since it's been leaking a little from the one side. I decided to tighten it down and when i did i stripped it! Now it's leaking 100% worse. WHat do I have to do to fix this???? I really rely on my car so please help!! I believe the bolt goes into the...
  6. bigsparky

    fan clutch

    How can you tell if it's gone bad? After fixing the water pump i noticed that there was a wierd vibration at 3500rpm. i removed the fan then started the car and the vibration was gone. Put the fan back on and the vibration was back. When i spin the fan there's resistance (doesn't spin...
  7. bigsparky

    Good deal??

    Should I buy some Ford "C" springs for 150 shipped to my door??? Let me know asap.. I don't know what the price is on them new
  8. bigsparky

    Stumbles at high rpm

    Ok tonight I raced an srt-4... and is it just me or are those things really not that fast??? anyways... I noticed at about 4500rpm my car seemed to stumble a bit.. most noticeable in 2nd and 3rd gear. I just replaced my spark plugs, fuel filter, cap and rotor.. the only thing i didn't change...
  9. bigsparky

    removing pulley off 3G

    How do I get the pulley off of the 3G alternator?? My main concern is stopping the pulley/fan from spinning while attempting to loosen the bolt thanks
  10. bigsparky

    re: cruise control

    I bought my car last august and the cruise control has not worked since i've owned it. Today I took some initiative and pulled the inner fender to check for cracks in the vaccuum lines, or disconnected lines. Everything appeared to be good. Next, I pulled the dash pieces off around the...
  11. bigsparky

    Will this be more restrictive than good??

    I bought some dynomax super-turbo mufflers for really cheap. Anyways, it turns out they're 2" diameter but i thought they were at least 2.25". I can't take them back but if i weld them in place of my stock mufflers, will this be more restrictive or not? For exhaust I have the factory headers...
  12. bigsparky

    Lowering 60fts

    I need to lower my 60 foots drastically. Keep in mind the last time i was racing it was a couple degrees above freezing, so traction was a huge issue. But my 60fts were around 2.5!! I only have subframe connectors for any sort of chassis stiffening. what would be the next step??
  13. bigsparky

    Code 31 help! PLEASE!

    My car runs absolutley fine. But at around 1500 rpm the check engine light comes on. It doesn't come on EVERY single time, but most of the time. It then shuts off usually around 2000 rpm. It doesn't matter if it's part throttle or full throttle, it still comes on. I pulled the codes and got a...
  14. bigsparky

    Hot starting problems... FACTORY headers!

    I've noticed for a little while that my car doesn't like to start AS good when it's hot. It cranks a lot slower than it does when it's cold. Then today, I came home from work, came in the house and did a few things, went back out and it wouldn't start, and still won't. I checked the voltage...
  15. bigsparky

    Saskatoon meet????

    We should organize some sort of meet.. I wouldn't mind meeting the mustang crowd in saskatoon
  16. bigsparky

    Dust cover on tranny

    I noticed the dust cover on the tranny that covers the hole where the cable goes into the tranny is missing. What kind of problems can this cause? If dust got in there could my clutch slip or squeek???
  17. bigsparky

    Do I need this piece?

    I put in my offroad h-pipe in today and while doing it, instead of hooking the smog tube back up, I had the bung welded shut so I can remove all the smog equipment later. So that tube that comes from the engien to the cats, I just pulled out where it connects to the rubber hose inside the...
  18. bigsparky

    header-midpipe bolt size

    I'm in the middle of an H-pipe install and I can't seem to find the right size for the bolts that join the header to the h-pipe. Does anyone know?? Please help
  19. bigsparky

    Clutch noise - NOT THE USUAL T/O bearing noise!

    It doesn't make any noise when the clutch pedal is out or in or any other time EXCEPT every once in a while it seems to squeek (best way to describe it but deeper sounding than a squeek) when I let off the clutch in 1st. It always happens at the same point in letting out the clutch and it seems...
  20. bigsparky

    smog tube/h-pipe question

    I'm putting in an offroad h-pipe in my stang and i WILL be removing my smog equipment later. I am wondering if it will be ok if I just leave the pipe that is supposed to connect to the h-pipe just hanging there, not connected to anything. Will there be any adverse affects? The reason I don't...
Top Bottom
Back
Forums
Menu