Search results

  1. Heratik

    Gear install - Bearing kits (y/n)?

    I'm going to rebuild my rear end with 3.73's and I'm trying to decide if it's worth it replace the bearings with the FRPP kits (M-4210-B and M-4413-A). Normally I'd simply error on the side of caution and just buy the bearings but cash is a little tight right now and I'd prefer to use the old...
  2. Heratik

    Low noise/dust pads

    It about time for my bi-annual brake job so I'll be needing some new pads. I've been very happy with the oem pads that came with my cobra calipers, they're quiet, don't dust much, and perform well. They're just really expensive, unless I've been looking in all the wrong places I've been seeing...
  3. Heratik

    Subframe welder

    I'm looking for a shop/person to weld on some MM subframe connectors in the SE Michigan area. If you have a place that you'd like to recommend please let me know.
  4. Heratik

    Tierod end recommendations

    Both of my outer tierod ends are shot and I'm going to replace them. My question is if I should stick with the OEM units or upgrade to an aftermarket peice such as MM end. On my car I'm really not sure if it would be worth the upgrade since it's so lightly modified. Also I'm a little concerned...
  5. Heratik

    Ground

    I've just installed a amp and sub in my trunk and I have a fair amount of light dim. I've got a Alpine MRP-M450 and a JL 10" running at 2 ohm and I'm thinking that perhaps I need to find a better ground. I hooked into a grounding screw on the drivers side of the trunk near the fuel pump reset...
  6. Heratik

    2 Ohm 6x8's

    I've been agonizing over the selection of the full range drivers that I am going to get for my Mustang. I'm going to replace my entire system from the head unit down to the wiring and I have everything pretty much selected except full range drivers. I really like the Infinity KAPPA680.7CS for...
  7. Heratik

    Creative amp placement

    I'm going to get a the Alpine MRP-F450 and the MRP-M650 and was wondering if it was possible to mount them under the rear seats. I've looked at it and it appears that there is enough space if I modify the padding on the bottom of cushion. Currently the padding fills the entire cavity under the...
  8. Heratik

    Projector HID kit by Stangmod

    I have a few questions in regards to the HIDS and projector housings that Stangmods is selling. Anyone own or have any experience with this HID kit or with that style of projector housing? Any opinion on brightness, light foot print, or general function would be appreciated. I've seen that...
  9. Heratik

    265/40R18's?

    Anyone running a 265/40R18 on their 18x9's? I've been looking into getting this size for a few reasons. This size works for the Cobra R so I am hoping that it will work for mine. Because the tread is thinner and the sidewall is taller I would expect them to have a slightly better ride then a...
  10. Heratik

    Stang Tires

    I've got a 2000 Stang GT. I've just replaced the tires with BF Goodrich G-force T/A KDWS. I noticed that my car now produces a rather loud hum at 30+ mph. So loud that it is difficult to hear the beautiful music coming out of my exhaust pipes. I was wondering if this could be due to the tires...
Top Bottom
Back
Forums
Menu