Search results

  1. 9

    Reintroduction

    I'm getting back to driving my Mustang again since I finally got her running/driving like a good daily should. It must have been years since I've been on this site since it uses my (extremely) old AOL email. I wrecked my 92 GT back in '13 and have since bought a red 93 coupe and swapped the...
  2. 9

    rack and mm shaft install

    im installing a cobra steering rack but i can't get the damn inner tie rod ends off to replace with fox inners. i feel like something is going to break inside the rack from the twisting. how much force can the rack take?? also, trying to get the mm steering shaft in but the steering column...
  3. 9

    Front brake line fittings

    I'm doing a 5 lug conversion on my 92. Got the rear done, now working on the front. I'm trying to get the soft line disconnected from the hard lines. Those fittings will not budge. I've tried PB Blaster, heating them up with a torch, and vice grips....nothing is working. Anyone have any...
  4. 9

    carrier pin won't go back in

    I'm doing a 5 lug rear disc conversion on my 92. I bought moser 28 spline c-clip axles. Axles go in no problem, put the c-clips on and pull on the axles. Go to put the carrier pin in, won't fit. Haven't heard anything on this before. Any help?
  5. 9

    Front control arm bushings

    I bought some prothane urethane front control arm bushings. They have a metal sleeve on there already. How do you get the old metal sleeve out of the control arm?
  6. 9

    lower control arm removal

    I started my suspension project today. I got my passenger rear spring out and the bolt that attaches the lower arm to the axle. I go to remove the body side bolt and that thing will not budge. It's soaking in WD40 right now, tomorrow I'll go get some Liquid Wrench and let it soak since I...
  7. 9

    Which lower control arms??

    I'm gonna be getting some new lower control arms. My car is daily driven but I do some auto-x from time to time. I was looking at getting the Pro3i street/race arms, they have the spherical bearing on the axle end. Are these arms what I am looking for?? Anyone have anyother suggestions...
  8. 9

    Power steering ?'s

    if i remove my power steering pump completely....do i need to do anything to bleed the system, or is it a self bleeding system?? How do i drain out the rack and pinion of the fluid?? How much fluid does it take to fill the whole system up?? Thanx
  9. 9

    A/C compressor pulley

    the pulley on my a/c compressor seized up. Can i just get a new pulley clutch thing for the compressor and replace that or do i need to get a whole new compressor?? If the latter, i might just remove the a/c stuff all together. If i do that, can i just go to a dealership and buy the...
  10. 9

    Porting E7's

    Would removing just the EGR bump in the exhaust port be a worth while job?? What other easy porting could be done yourself?? I'de like to get Thumper heads, but can't you get some stock E7's from the junk yeard for cheap??
  11. 9

    T-5 on a 260

    We're rebuilding a 260 in our 64 1/2 vert. Question is, will a T-5 work on a 260? I know they make adapter kits for the 289, but what about the 260?? Thanx in advance.
Top Bottom
Back
Forums
Menu