Search results

  1. W

    Stock 93 Radio Question

    I've got a stock radio in my '93 worker Mule and it crapped out. Went to the junkyard and found lots of radios that look just like it, but the plugs on the back are wrong. Mine has one large plug like the others but also has a small square plug on a blue cable that goes to what I guess is an amp...
  2. W

    93 Stocker won't Idle

    My old '93 suddenly won't idle. It's not hot rodded at all, just my work mule and has been a real good one for 250,000 miles. It still gets good mileage and runs great too, it just quit idling. I can keep it running if I keep my foot on it but it will shake and die if I let it go below 1000 rpm...
  3. W

    IRCM Relay Box $?

    Anybody ever repaired one of those IRCM Relay control boxes for the fuel pump and fan relays? My pump relay is sticking and I have to smack the box sometimes to get it to start in the morning. Are there any parts you can get to in there, or is it all "Potted" in that rubbery stuff? Replacement...
  4. W

    Sticking throwout bearings

    I'm on my Third Clutch replacement now because of the wear I get on the trans. bearing support sleeve where the throwout bearing slides. The clutches and pressure plates are fine, just the bearing retainer sleeve wears out where the throwout bearing slides. It gets progressively stiffer and...
  5. W

    Sticking Throwout Bearings

    I'm on my Third Clutch replacement now because of the wear I get on the trans. bearing support sleeve where the throwout bearing slides. The clutches and pressure plates are fine, just the bearing retainer sleeve wears out where the throwout bearing slides. It gets progressively stiffer and...
  6. W

    How Do you Clean Harness Connector plugs?

    I've heard that corrosion on some of the pins in the harness connectors might be the cause of DIS failures. I've damaged two of the modules now so that the Tach. only shows 1/2 the real rpm. Idle is rougher and standing starts seem like the engine timing is retarded. It runs OK when I get it...
  7. W

    IRCM "Black box"

    I've got a fuel pump relay problem. Some times in the morning I have to whack on the black box on the pass side fender to get the fuel pump to wake up. Today I took it off and opened it up and it looks like the relays are sealed and soldered to the ckt. board inside. I'm thinking I will have to...
Top Bottom
Back
Forums
Menu