Search results

  1. armoore98

    Front Wheels Shimmy On Easy Right Turn

    I have an 05 GT with 215000 miles. I've replaced both lower ball joints and all tie rods but I can't get rid of a shimmy . It usually happens around 60 mph and only when making a slight turn to the right. If you are turning very hard it will shake just as you start to turn, then stop when it...
  2. armoore98

    Pinion Seal Replacement

    So my 05 has 155,000 miles and the pinion seal has started leaking a little. Not bad, but just wondering if I should pull the cover and replace all of the oil in the rear, or just top it off once I am done with the seal. If I change the oil, is there anything or special oil that I should put...
  3. armoore98

    IDLE CIRCUIT MALFUNCTION

    car seems to idle slower than normal and now I am getting a idle circuit malfunction on my 05 GT. Just wondering if anyone else has had this issue.
  4. armoore98

    guages not reading correctly

    My 2005 GT seems to have a strange problem. About half of the time the coolant guage does't read, and occasionally the charging guage reads very high, when I know it is not actually charging incorrectly. I was just wondering if anyone else has witnessed this
  5. armoore98

    SHAKER 1000

    I am not sure about anyone else but I wanted to share with everyone about my shaker 1000. I could not play a cd of any kind without it skipping and ejecting the disk with a bad disk error. Then I burned 6 cds with the mp3 format and I am very excited to say that it has not skipped or had any...
  6. armoore98

    canister purge sensor

    My ses light came on with the po443 EVAP canister purge control solenoid or valve faulty. I changed the valve under the passenger front fender but after resetting the ecu, the light immediately came back on. I was told that the folks at ford change that valve and the sensor at the same time...
  7. armoore98

    Check Gas Cap and SES lights fix

    I have just had to have my 2001 Stang repaired for this problem. My mechanic had to get a smoke machine to find the leak. The SES light code refers to a large leak in the emmission system. It is refering to a leak in the fuel tank. The filler neck has a plastic insert where the cap screws in...
Top Bottom
Back
Forums
Menu