Search results

  1. G

    Need help quick!! Felpro 1415 ?'s

    Hey everyone, I am in the middle of my header install and have a really dumb question. I purchased felpro 1415 for the gaskets, but need to know which way they are supposed to be facing. One side is blank and flat, and the other has the part number and "Felpro" on it. Thanks...
  2. G

    Anyone running MRT Aero Turbine axle backs?

    Hey there fellas, I just picked up the aforementioned axle back for a real good deal, so I'm gonna give them a shot. Do any of you guys run this axle back? Any impressions on the sound? For those interested, the axle back should arrive later this week. I'll post several before...
  3. G

    Need opinions, quick!! O/R X w/ stock axle backs

    Hey there everyone :D I have the opportunity to pick up an O/R x pipe tomorrow for a great price.........but I need to act fast before someone else snags it! I'd like to hear some of your opinions/experiences you've had with this particular exhaust combo. It's going to be put on my 05 GT...
  4. G

    AODE trans tuning

    Hey everyone :D I am looking for a (cheap) chip that will just control the shift points and firmness of my slushbox........I'm running 4.10's in the rear and am tired of having to lift to avoid bouncing off of the limiter. Can anyone point me in the right direction? Thanks a bunch...
  5. G

    S&B Cai w/ canned tunes?

    What's up fellas, Can I use this "No tune" CAI setup with the canned tunes from either major flash device? Would I just have to chose the stock air box setup? Please educate me as I am a 302 guy........this is for my wifes car. Thanks! -James
  6. G

    starting/stalling issues

    Hey everyone, I had a thread going a while ago regarding my 94 GT's no start problems. Well, long story short.......mechanic found my injector harness to be toast and replaced.........all was well on the drive home. Since then the car has stalled on me like 12 times (Everytime it...
  7. G

    no start=big problem... need help!

    Hey everyone, So here is the deal w/ my car problems; Two days ago my car just cuts out and dies on me while idling in a parking lot. I was able to pull codes and found the problem to be a faulty PIP sensor.........no biggie. So I got a reman'd dizzy and reinstall, but the car...
  8. G

    installing timing chain

    Hello everyone, I will be replacing my old timing chain with a new one from Ford Racing. I have never done this swap before and was hoping you experienced guys could give me a few tips/pointers. Now for a couple questions...... 1.) The new chain came with some sort of plate which...
  9. G

    timing chain sprockets!

    Guys, I am ordering a new Ford Racing timing chain part #FMS-M-6268-A302. This is for my street car/daily driver. Do I need the chain set with the iron sprockets or the steel ones? Thanks in advance! -James 94 GT
  10. G

    quick pro-m maf?

    Hey guys, I recently purchased an older pro-m bullet meter. I was told that is the old school 77mm style bullet . Anyhow, the meter is cal'd for a cobra w/ 24 injectors, not a 19lb injector calibration. I have a GT that I'm planning on running with 24lb injectors. Is this meter gonna...
  11. G

    quick temp gauge wiring ?

    Hey guys, I am in the middle of wiring up an aftermarket water temp gauge and would like to splice the lighting of the gauge into the factory dimmer switch wiring. What color is the wire I am looking for? Thanks, James 94 GT
  12. G

    Walbro install kit?

    hey fellas, I was given a walbro 190 fuel pump from a friend minus the pigtail/rubber hose/install kit. Right now I have a stocker in tank. My question is....... Does the stock pump pigtail harness fit a walbro pump? Can I just swap over the stock stuff to the walbro (Excluding the...
  13. G

    Another A/C thread

    Hey guys, I really need help with recharging my a/c. I am completely new to a/c work so please be patient. I will try to describe what is happening the best I can, so here goes....... Basically, I have nothing but hot air coming out of the vents when the a/c is on. I have one of...
  14. G

    Rag joint

    Hey guys, I need some help locating a stock replacement for the steering shaft in my car. I have called all of the part stores and none of them seem to carry it. What has everyone been using as a replacment? Also, I can't drop a few hundred on a flaming river piece right now, so that...
  15. G

    HELP! need info on TPS and TB

    Hey guys, I need a quick rundown on the throttle bodies and the throttle position sensors for our cars. Here is the situation............. My car is with the dealership mechanic right now (Out of warranty) and among the various problems with the car he is now telling my that the TPS...
  16. G

    gt40p valve springs

    What's up guys, I recently pick up a set of used p heads that are completely stock and supposedly pulled off of a running mustang. I have read that the stock valve springs suck on these heads. My question is...........how much lift can these springs handle in stock form? I am...
  17. G

    harmonic balancer install help!

    have a retarded question for ya'll.... How in the heck do you get the crank pulley bolts and balancer retainer nut off of the car? Everytime I try to loosen them the entire balancer wants to spin with the pulley and I'm not making any progress. And no I don't have air tools! Any help would...
  18. G

    Galpin Ford idoits

    hello all, I need some information on possible damage done to my car. The back story: My wife and I got a 05 GT five speed last December. For those who aren't aware, the new GT's have a recall on their fuel tanks and CD players. Anyhow, last week I take the car in to have the gas...
  19. G

    code 121

    hey guys, I pulled this code.... "121 O,C,R Throttle Position sensor out of self-test range" today and was wondering if anyone else has pulled this in the past and what you did to fix it. My car has a pretty high idle at startup (1100 rpm). There are no vacuum leaks and I have a BBK...
  20. G

    can someone tell me how...

    to adjust the height/stiffness of my gas pedal? Mine used to feel like it was almost even w/ the brake pedal, but after messing around with the car (Changing the intake manifold) I've noticed the pedal is noticeably lowered with a much softer feel to it. 94 GT
Top Bottom
Back
Forums
Menu