Search results

  1. N

    Converting to 10.5 inch clutch on 2004 GT?

    My clutch is fine, but my TOB is squeaking pretty bad, and I figure if I'm going to go through the trouble of pulling the trans off, I may as well do the clutch while I'm in there. So here's my question. I just finished reading on Maximum Motorsports' website that Ford used a non-conventional...
  2. N

    Coilovers on Daily Driver?

    I've been thinking about installing coilovers on all corners of my '04 GT, which is my daily driver, and I was wondering if there are any negative aspects of this decision? I've searched around and found a good amount of information about coilovers in general, but no discussion about coilovers...
  3. N

    03 Cobra Hood on 04 GT???

    I have an opportunity to buy an 03 Cobra hood used for cheap and I would like to put it on my 04 GT, but someone just told me that it won't fit on my car without the Cobra bumper as well. I want to keep my front bumper so is there a way to make the hood work or should I just scrap the idea? Thanks.
  4. N

    Options for brake upgrade

    OK, I have a 1969 Mach 1 with the factory single piston brake calipers. I want to do a brake upgrade, but all I can find is kits that cost $1000+ to upgrade to huge rotors that are drilled and slotted for a car that originally had drum brakes in front. I don't want to do anything that fancy or...
  5. N

    Quick Nitrous Express Question

    Does anyone have a picture of the NX Fuel Rail Adapter installed on an '04 GT? I'm ordering mine this week, and I'd just like to get an idea of how it works before it gets here. Also, for a 100 shot, does anyone know where and which NX jet kit I should buy? I'd like to jet the setup for 75 to...
  6. N

    Mae Racing... WTF???

    Has anyone heard anything about Mae Racing lately? I was referred to them by a friend a few months ago and ordered a new center section for my car. After a month I sent them an email asking when I should expect it. They said 5-10 days to ship. Another month went by and I've emailed them several...
  7. N

    3650 behind a 351W?

    I have the opportunity to get a T3650 for free and was just wondering if it's possible to put a new T3650 behind the 351W in my '69 Mach 1. I suspect that there isn't a bellhousing that will bolt up to a Windsor motor but I just wanted to see if anyone knew of a way to do it. Thanks.
  8. N

    Clutch Pedal for '69 Mach?

    I'm starting to collect parts to swap a TKO into my '69 Mach 1 which currently has the stock FMX and lately I've been searching for a clutch pedal assembly. I see plenty of places that carry clutch pedals for 64-66, but I have yet to see a company that offers them for '69s. I was just wondering...
  9. N

    Fuel Rail Question

    I want to install a fuel pressure gauge in my car, but I have an '04 without the valve on the fuel rail to tap the system. Rather than buying the adapter fitting, I was wondering if I could just find a junked '02 or '03 GT and grab the stock fuel rail off of that? Unless there is an easier way...
  10. N

    Best sub-frame connectors?

    Hey guys, I've got a '69 Mach 1 that I'm going to start working on soon and I want to stiffen the chasis before I do anything. I've been looking around for a set of sub-frames, but some of them require modifying the floor pans. What's a good sub-frame I can get without having to modify the car...
  11. N

    Ford Racing 31 Spline Rear Diff.

    I'm starting to look into building up my rear end for more power and more traction, and I'm looking at getting a pair of Moser 31 spline axles, and I was wondering if anyone has anything to say about the Ford Racing 31 spline TLOK rear differential. I know most people go with Auburn or Eaton...
  12. N

    Quick 351W question

    I have a '69 Mach 1 with the 351W engine, and I was wondering what the combustion chamber volume is on the stock heads? I can't seem to find out on google or searching the forum. Thanks.
  13. N

    MRT suspension kit?

    Anyone have the MRT suspension kit that comes with Tokico shocks (not the adjustables) on a 99-04 GT? The part number is MRT-301 on the mustangracing.com website. I want something to drop the car just enough to get rid of the 4x4 look, but nothing too drastic and these seem like a pretty...
  14. N

    Hypertech vs. Predator?

    Title pretty much says it all. Anybody have experience with both of these programmers that has an opinion as to which one is better? Or are they pretty much the same? Thanks.
  15. N

    Installing tri ax shifter tonight

    I just got my new tri ax in the mail today and I'm about to go install the thing, but I just wanted to check and see if anybody has any advice on how NOT to break the center console piece that's gotta come out to do it. It's going in an '04 GT and I don't know if there's some trick to it besides...
  16. N

    Mac Prochamber vs. X-pipe?

    I just bought an '04 GT and am getting ready to start with the usual mods, but I'm new to late model Stangs, and I was wondering if anyone could tell me the difference between an X-pipe and the MAC prochambers since they both seem to merge in the same fashion? Also, in addition to that if anyone...
Top Bottom
Back
Forums
Menu