Search results

  1. D

    lug nuts to narrow

    I noticed after finally bleeding my brakes that the lug nuts are really wearing on the wheel. When I tighten the lug nuts some of them cause metal shavings to come off the wheel. The holes where the studs come through is just barely smaller then the diameter of the lug nut. Is this normal for...
  2. D

    speed bleeders

    I ordered some russel speed bleeders from summit part no. 639590 I dont think this is the right one though cause it seems to short and narrow. Im not really sure. I took the original bleeder screw out. the threads on the speed bleeder do match the threads on the caliper but just a tad...
  3. D

    Rear brake locked up

    I drove to the store and set the e brake which i pulled pretty hard on accident(my other car you have to pull pretty hard). Got back in car to leave and I could tell one of my brakes was locked up. Drove about 3 miles home and the driver rear was real hot, took wheel off and removed two...
  4. D

    Stangless no more!

    So I finally picked up another mustang. It had been about 1.5 years since I sold my Mach 1 to buy my house. Now that im somewhat settled in, I decided to get another stang. Its a 98 gt with the powertrain out of an 02. It is a 5 speed but used to be an auto. The guy I bought it from was a...
  5. D

    Opinions please!

    Im ready to buy a mustang only have 3-5k to spend. I would prefer a car with a lot of the maintenance already done and some decent power. I emailed the owner and he said it went 12.8 @ 110mph on slicks. Does this seem like a good buy if i can get him down closer to 4k. Does that ET seem...
  6. D

    4V bamachips tune

    I always here the S197 crowd getting the Bamachips tune. Has anyone with a Mach 1 ever gotten a tune from Bamachips? Did you feel much of a SOTP improvement? How about dyno numbers afterwards? I dont have a tuner close to me, so im looking for a good custom tune without getting on the dyno...
  7. D

    CEL's

    Heres the list- P0443, EVAP Canister Purge Control Solenoid or Valve Faulty. P0135, Upstream Heated Oxygen Sensor Heater circuit fault - Bank No. 1. P0136, Downstream Heated Oxygen Sensor circuit fault - Bank No. 1. P0141, Downstream Heated Oxygen Sensor Heater circuit fault - Bank No...
  8. D

    Rubbing with 315's

    I just installed some Deep Dish Bullits with 315's:drool: . On the right side the Bassani catback exhaust pipe is about 1/4" from the tire. The left side is fine with about 1 1/4" inch clearance. I tried to adjust the exhaust tubing from when it leaves the muffler and move it left and right...
  9. D

    Tire Questions

    Hey, I think I finally decided to get the Chrome 18inch Saleens from American Muscle. Are the Sumitomo that AM has good? I would rather get BFG's. Is it better to buy the wheels and tires in one package or buy the tires separately? I think I want the 285/35/18 in back and 255's in the...
  10. D

    Finally, got my pics

    So I bought a mustang three weeks ago and just now found my camera cord, so I could upload some pics. It is a 2003 GT 5spd. I wanted a Mach 1 but determined they were out of my price range. This is my 3rd "New Edge" Stang. This one has the least amount of miles, of any of the others (23k)...
  11. D

    Clutch pedal hard to push in

    I just got a 03 GT and noticed that the clutch is hard to push in. Ive owned a 99 and a 01 in the past and neither felt this stiff. The car only has 23k on it and my mom actually has a 03, and her clutch is not as stiff to push in. Is there something that needs to be lubricated or is it...
  12. D

    05 GT or Mach 1

    Hey guys within the next 3 weeks I would like to purchase another mustang. Right now I have a Mazda 3. I have previously owned a 99GT and 01GT. I just got out of school and found a decent job. With the extra cash i want to get either an 05GT or 03-04 Mach 1. Both of these cars are going for...
  13. D

    50-130 pull with RSX type S

    Well a year ago, as gas went up I decided to trade my 01 GT for something more fuel efficient. I went with a Mazda 3, which is suprisingly fun. I hope to keep it and buy a new stang when i graduate in May :D Well being the huge mustang fans my family is I occasionally drive my parents Stock...
  14. D

    SVT Adrenalin

    What do you think of the new SVT Adrenalin that comes out in 07. I like the looks of it and with 390hp and AWD its definetly going to be quick. I loved the lightnings but i guess Ford wont be making any for awhile. Motor trend says estimated price for the adrenalin is 35k, i think. Im kind...
  15. D

    Help Deciding on midpipe

    I need to know what will sound better with my loudmouth :hail2: exhaust. I am deciding to go with a catted mid pipe to pass emissions. Will the Magnaflow catted X, the MRT catted H, Catted Prochamber, or something else sound the best. Most of these cost an arm and a leg so i want it to be...
  16. D

    Emissions testing?

    How often do you have to have emissions testing done? I got my 01 in August and got an emissions letter in March. I want to get a Pro Chamber to go with my SLP exhaust, but i dont want to be switching out my old H every year. I thought i heard if you have a newer car you only need to get...
  17. D

    New wheels

    I am looking at buying a new set of weels for my 01 black stang. Has anyone seen black bullit wheels on a black GT, I found the black bullits for $130 a piece with free shipping. I think they will look good, but i havent seen any pictures. Does anyone have this setup, how does it look?
Top Bottom
Back
Forums
Menu