Search results

  1. 95GTV8

    Clutch Noises

    For the last three weeks strange noises have been emanating from my clutch. When I would push my clutch in the slightest bit I could hear a squeaking/squealing. As time went on whenever I shifted gears the clutch felt a little rough and now last night I can hear more of a faint grinding when I...
  2. 95GTV8

    Exhaust Rattling

    I'm having fitment difficulties with my new Borla catback I installed. The passenger side tail pipe is not quite flush with the driver pipe, and a result it will rattle sometimes. I'm positive the problem lies within the passenger side tailpipe because when I shake the driver side tailpipe I...
  3. 95GTV8

    What's harder to tune?

    I'm thinking of either doing a H/C/I or a supercharger. I'll be adding aluminum heads, either AFR, Trickflow, or Edelbrock and the most 94-95 friendly Cam I can find. On the other hand I could add a supercharger. Which will be harder to tune? Will i need a tweecer for both, or only...
  4. 95GTV8

    Saw 2 Mustangs today in Tacoma

    I saw a red and a black mustang hauling ass down bridgeport in tacoma. The red had a big cowl hood and sounded mean. I think i saw them between 19th and 27th street. I was wondering if they were on this board. If the owners are, it was a nice sight :nice:
  5. 95GTV8

    Borla exhaust tip discrepancy

    I recently just finished installing a borla catback system on my car. The install was fairly straightforward except the driver side tip hangs out about 2" more than the passenger side tip. I'm wondering if anybody has had this problem before or if anybody has any remedies.
  6. 95GTV8

    Volvo Problems

    My friend has a 01 s60 T5, and she's very ill. I think the engine is hydro-locked. There was standing water on the streets and we had to get to downtown and all of these other cars were going through the water fine, but right when we were leaving the last bit of water his car bogged down, and...
  7. 95GTV8

    Borla Catback Install

    I spent yesterday morning intstalling my new Borla Catback. Getting those rubber exhaust hangers off the stock catback is a bitch. Once I put the new borla on I had trouble hanging them on the hanger which is closer to the front of the car. The rear hangers I was able to do fine, but the...
  8. 95GTV8

    Battery Cables

    As it turns out i have corrosion on the inside of my battery cables. Do you guys have any preferences on what type to get for a new cable? By wiggling the positive cable while it's still attached to the battery i can make my car gain/lose power.
  9. 95GTV8

    Ughhh... Battery problem...Need help.

    Allright, so the other day I got a new battery, but as it turned out my starter was shot-got a new starter everything is fine. While we were putting the new battery on, to combat corosion my dad put these pads on and some vaseline on the connections. I'm driving home and the car starts shaking...
  10. 95GTV8

    Any Cigar Afficionados?

    Anybody here really enjoy cigars?
  11. 95GTV8

    IAC? god this is frustrating

    I just had my starter motor replaced. Car starts fine/drives fine. Now when I put the car in neutral about 65% of the time it dies. I thought it was the IAC so i cleaned it out with carb cleaner and that seemed to work for a day. I turned the car on after doing that let it idle for like 2...
  12. 95GTV8

    Starting Problems

    I tried to start my car the other day, and it turned over but no start. I tried again and then it wouldn't even turn over. I figured it was a battery so i went and bought a new battery and put it in, and still it just clicks. So the problem must be between the battery and the starter. The...
  13. 95GTV8

    Small Annoying Problems

    I have a few problems, quite annoying, and i'd would like to get them all fixed. I'll list the symptons below and if anybody has any ideas it'd be greatly appreciated. #1 Car doesn't start very easily. I received a tip on SN to prime the car a couple of times, let the fuel pump prime etc. If...
  14. 95GTV8

    Wheel Questions

    I'm looking @ some 17inch 95 Cobra R rims. What type of width is best? My car is mainly on the street. 17x9 and 17x10.5? What are some good combos? Thanks.
  15. 95GTV8

    Balljoint + Allignment

    The local shop is replacing my balljoint and they said it will also require an allignment. They're saying about 2 hours for each. Am I getting ripped off? Or is this fair. Thanks.
  16. 95GTV8

    Squeaks & Rattles

    I have squeak which appears to be coming from the front passenger side wheel area. It squeaks constantly when im driving and it's worse when im going slow because you can really hear it. I've also noticed that when im pulling out of my driveway and i'm turning my steering wheel all the way to...
  17. 95GTV8

    Larson Automotive Group

    This outfit, aka Robert Larson, is no good. They are complete schiesters, and on many occasions, have tried to scam my family. My mom has a jeep grand cherokee, and they've tried numerous times to make her pay for things that fell under her warranty. We've recently decided to take it to Hauling...
  18. 95GTV8

    Cylinder Heads & Tune Problems

    Well, since summer is rolling around i'm thinking more and more that i want to throw a set of cylinder heads on my car, preferrably aluminums. I'm looking @ edelbrock performers 1.90/1.60. Seems i'll be able to get the best deal price-wise for a set of those. The only thing that is holding me...
  19. 95GTV8

    Factory Touch Up Paint

    Anywhere know where i can find some factory E8 (rio red) touch up paint online? I've looked at all these places but you have to tell them what you want and then they make it and ship it out. I'm wondering if anybody knows of a place where they have it stocked? I have a lil scratch on my...
  20. 95GTV8

    CAI Q

    I now CAI's doesn't really do much for power but i'm thinking of getting one for looks and to clean up the engine bay a little. I currently have a K&N air filter and i'm wondering would the K&N designed for the stock airbox fit onto a Fenderwell style CAI? The K&N is probably 5-6 months old and...
Top Bottom
Back
Forums
Menu