Search results

Are any of the 9 inch rears a posi and will they bolt into a 71 Mach. very interested. Thanks, Jesse

if you have not already sold the 8 with the 340 s plsea email me back or if you have anything else that will bolt into a 71 mach with a 8 inc now. Thnaks, Jesse ([email protected])

Did you put any sealer on the bolts that connect your flywheel to the crank. These bolts holes go completly through and will cause a leak that looks a rear main seal leak. Very common but not to commonly known. hope this helps.

Hi, I have just about finished my 71 Mach restomod project. Its has a Fuel injected 347 with complete BBK intake setup, Powerdyne Supercharger and built C4 trans with shft kit and hammer shifter. Now I need some advice on what to do with the rearend. I hit the gas 1/4 throttle and its one...

WOW, thanks for the quick response guys. I will look under the car and check the h pipe for the 02's if there are none where would I get these bungs?? Can I get a bigger pump at my local auto parts store or Jeg, Summit better. Thanks again, Jesse

Hi, I just bought a 90 gt with a new motorsport 302 create motor, BD-11a charger,BBK upper and lower, BBK headers,BBK rails, complete msd ignition,be cool radiator and elec fan set up ect ect..... The motor seems to be pro installed but not completely finished.. I just got a good look at the...

Hi, thanks for the reply. I dont think they have had any mill work, just ported and polished with a valve job, new springs, guides and procomp 1.6 rollers. So you think the stock push rods will work? I just bought these heads off a guy who switched to gt-40s. I got the heads with everything...

Hi everyone, I have a 302 and I am installing a set of 351 DOOE heads with procomp 1.6 roller rockers. I am wondering if I will need to put different size pushrods in or if any other mods are needed to make this combo work. Will I notice a hp increase over the stock 85 302 heads? Any and all...