cleveland fan
cool another guy whos building a cleveland...i put one in my 89 coupe no prob..(headers where kind of costly at the time..headman where the only ones doing it at the time..(7 yrs ago)..anyway..its was a 72 block from a torino..70 closed chamber heads..you did not say if yours...
fuel pressure....
i put a cleveland in my 89 coupe..to get to fuel pressure down i installed a moroso fuel log and holley regulator to get to the required 6psi..i ran a high volume motorstors fuel pump in tank with the set up....(you will have to install the required washers in the log to get...
rebuilt 4 sp trans for sale,,came out of a 70 torino 351cj ..was installed in my 89 mustang coupe w/351c....was rebuilt by pro gear trans in orl fl..worked great but i bought a richmond (R.O.D 6SP) and am now using that...this trans can take alot of h/p..nitrous ..blower no problem..need a...
anybody looking for a machined 28oz hayes flywheel fits 5.0l and 351 c or w..also have a new center force clutch disc dual friction 10 tooth (for 10.5 of a stang..also for sale....
most likely it s=has 134a fittings on it..if not u can get freeze 12 to put in it to replace r12..but if you r doing a repair on her they go to 134a ..
can you get block numbers and are they 4v heads 4 sure?(look for the 4 in the corner ..and ck for the oem part # they might be closed champer heads..which is good...i have an 89 coupe and put a 72 351c block and a set of 70 closed chamber heads.. a crower mech cam ...crower h-beam rods..je...
the plates should have enought adj to correct it..i would get another place to ck it again...was everthing ok b4 the swap..has the car ever been wrecked b4?..check the lower a*arm bushings?......
try and get a t5 from a 5.0l cause they are stronger and u pay about the same for the v6 one and it will last longer.. the output spline is the same as the aod but u might need to install a spacer on the rear of the driveshaft ...just ck the depth of the yoke in the aod b4 u take it out and...