Search results

  1. superdavestrate

    Spark No Spark

    Update... after sending my 6-al back it ended up having a problem and was fixed for 50.00 reinstalled and fired right up thanks for your help!
  2. superdavestrate

    Spark No Spark

    I believe I have checked all off the list above still cannot figure out why it will start perfectly one moment and will not start the next ,I have the spark tester in between coil wire and coil so I can visually observe when it has fire...it goes from having fire and the next minute none ...stumped
  3. superdavestrate

    Spark No Spark

    I'm back with some results,went on and replaced dizzy,with brand new one ,dropped it in car fired right up shut it off would not start.checked msd by jumping it and checking for spark ,it passed.checked ignition fuse with test light koeo.. passed.checked ignition wires near coil for 12 volts it...
  4. superdavestrate

    Spark No Spark

    Okay ,checked tfi it passed ..guess I'll keep looking.Put dizzy back in fired up first try let it run for about a minute turned it off ,tried to crank it no spark at coil wire wth!
  5. superdavestrate

    Spark No Spark

    thanks i'm on it...
  6. superdavestrate

    Spark No Spark

    Pulled the 93 out for a drive,started fine stopped at gas station and would not start.pulled coil wire.. no spark. I let it sit and it started so I shut it off and tried to start no go! last time it was the module that went down .running 6-al box and coil with stock dizzy and if you let it sit...
  7. superdavestrate

    Engine Decisions O' Plenty

    anderson n-41 278 in/286 ex at 0.50 222/230 gross lift 512, 110 ls ...I think this is a good choice with the gt40s going to add a alexs parts spring kit good up to 560 lift,maybe a typhoon intake from blue oval or use my cobra intake not sure or and I may rid of both cobra intakes and ditch the...
  8. superdavestrate

    Engine Decisions O' Plenty

    Was looking at the Anderson N-41/n-412 probably still have to go with bigger spring but the cams look great,seem to be top notch and should work with cobra intake and my heads. does anybody have any suggestions or input on cams ?
  9. superdavestrate

    Engine Decisions O' Plenty

    will do,thanks
  10. superdavestrate

    Engine Decisions O' Plenty

    so i'm ready to start my 93 upgrades and I have some questions>I have a set of gt40 heads off a lighting ,all machine work has been done.I have a f303 cam 1.6 rollers a non egr cobra knock off intake,70mm tb,70 maf,shorty headers 410 rear and t5..I don't think i'm going to use the intake because...
  11. superdavestrate

    typhoon intake

    Has anybody tried one of these I know they are some rough castings sometimes but I have heard good and bad about them was thinking about using one instead of my cobra intake?
  12. superdavestrate

    head gasket set

    I'm doing a head and intake swap on my pony, gt40s cobra intake, f-303,what are the best gaskets to use for head and intake .I always used fel pro permatorque in the past with stock thickness Thanks!
  13. superdavestrate

    Vibration Problem

    It seems to stay as it increases, I think I have another vibration i can feel in the shifter,maybe carrier bearing,axle bearing,or shaft but has worst vibration with clutch pushed in around 2500rpm
  14. superdavestrate

    Vibration Problem

    I'm having what feels like an engine vibration at around 2500rpm driving or coasting down the road or just sitting still withe clutch pushed in .As I raise the rpms it comes in very noticable at 2500.I have changed motor and trans mounts and will check balancer one more time,any thoughts?
  15. superdavestrate

    MAF question

    Will a 94/95 MAF be the best to run on my 93 ecu with gt40s,cobra intake,f-303,65mmTB,19lbs injectors,1.6 rollers,t-5,and 4.10 ratio just trying to upgrade thanks
  16. superdavestrate

    vibration problem

    I have a vibration in my car,checked balancer,changed tire and wheels,does it with clutch pushed in also its like a total car vibration,have not balanced drive shaft,could it be a axle bearing,or rear end gears set up wrong maybe? THANKS
  17. superdavestrate

    5.0 upgrade help

    Okay long time no talk,but I would like some opinions.I purchased a set of f3zeaa gt 40 heads heads,with ford blue 1.6 Rollers,f-303 bump stick,BBK 65mm TB,looks to be a aftermarket cobra upper with exploder lower with spacer (no ect hole) for 500.00 bucks.The heads have two bent valves in each...
  18. superdavestrate

    no low beams

    will do thanks
  19. superdavestrate

    no low beams

    Got into my car and no low beams,or fog lamps.High's work FTP works, interior and running light's work,had noticed awhile back that I had to wiggle headlight multi function switch real fast back and forth and headlights would come on so I'm assuming that mf switch is bad or loose wire any...