Search results

nice write up. ive always thought about how they come out especially since i have new window motors for the quarters. you wouldnt happen to know how or where i can find a write up on how to put in the rear seats from a fox coupe into a convertible?

the intake has to be the same design as the stock lower intake due to the way the twin screw bolts onto the lower. no i have not gotten it dyno'd yet, but will soon. So far i will be putting on the LT's and getting my lower ported, but what about Cam? what should be a good cam?

My car feels like there's ALOT left in it but I think between my lower intake (already in talks with tmoss to port my lower), heads and cam, there might be a mismatch issue going on. I have Trickflow pistons and BBK Longtubes but not sure if itll be worth the hassle of putting them on. Here are...

ok so i figured out this much. ive changed my start up fuel to -40 % and idle fuel to +14% in my boost tables i had -14* timing at 1 psi to -0* timing at 10 psi max. then i changed it to where it didnt take out timing when i came into boost and to be honest i really dont feel a...

Hey i finally installed my KB 1.5l on the 5.0. I hooked up the map sensor, PMS series IV, boost/vacuum gauge and my AFR wideband gauge. on start up the afr gauge reads 14.1 ish and the vacuum gauge and manifold pressure read -11 or 11 vacuum. the idles fine but only at 1000 rpms, anything lower...

im going to start this project in about two weeks, im just waiting on my gauges, bolts and gaskets.... should be awesome.

Hi to all. im new to the site. i have a 89 gt vert and i have ideas of things i think i want to do with it. the block is a 302 bored to a 306 with TRW pistons, a crank from a 93 cobra (was new when it was put in). the car also has a X-cam according to the previous owner. The heads are the...

but just changing the faces wont make the it read 140 mph. itll point at 40mph when your actually going 20....lol

when did this start? after a mod? like mentioned above, be a little more specific. does it make a popping noise that may sound like exhaust popping? when my maf went out, it would sometimes pop like crazy especially when the car was cold

mine does both of these. i always thought the bucking was because i wasnt going fast enough for the gear bc if i downshift, it drives fine or if i give it throttle, it drives fine until i let it idel and it slows down again. also my rpms also take a second to drop when i push the clutch in...

+1 the 90-93 years clusters are shaped a little different and dont directly bolt in the 87-89 years. but the 140 gauge was used starting in (late) 89 so you would need to find a 89 140 mph gauge. i dont recommend taking the speedo gauge off of a 90-93 cluster and trying to piece it into the 89...