Search results

Factory control arms with brand new Energy poly bushings. Cleaned and painted they look brand new. Used only for mock up and then replaced. $80 plus shipping. Paypal preferred. Thanks for looking. Frank

Wire the output source from the alarm to a tyco relay to activate it. Run "hot' power to the switched contact of the relay and from the relay to the trunk latch. There is no need to disconnect the existing wiring since the relay is going to keep anything from back feeding.

Thanks, Shane. I sent you a PM back as well.

Shane, What kind of shape is the X303 cam in? How many miles etc.? Frank

Sending you a PM.

Wes, PM'd you about the cam again. Frank

X2 on the VSS (Vehicle Speed Sensor). The speedometer works off the mechanical part of it and the computer gets it's reading from the electronic part of it. It will do exactly what you are describing if it has stopped working or is working intermittently. Note that the speedometer will still...

Your all set with the drive shaft you already have. Go for it.

X7 on getting new gaskets. Remember your going to have to follow the torque sequence when tightening the heads down and you'll have different torque values for the bolts that you use sealant on versus the ones you use oil or assembly lube on.

I had a 93 with an auto that did the same thing. There was actually a TSB for the car back then and the dealer replaced the balancer for free.

X2 on a ground issue. Make sure the wires are tight in the terminal and that the terminal itself is tight.

nevermind.

I'd like the shifter if it's still available.

Put me in line for the cam. PM sent