Search results

Hello all, I need to know where this hose goes to from the back of the plenum? Mine is cracked and leaves a black film on my hand when I touch it. I also need to know the size so I can replace it tomorrow before I get on the road. Any and all help is appreciated.

Hello all, I am having an issue with this window. Powered window. It goes down no problem BUT when it hits bottom the motor still clicks when you do the auto roll down with the double press. When rolling it up it goes halfway no problem. Then it goes nunununununun and will only go up if I pull...

To gain more pop off a stop?

It has Borla exhaust and it’s lowered properly. I want a little more off the line punch. Stock throttle body with that K&N cold air intake is what I have so far. What do tunes run?

Nothing else done except Borla attack exhaust. What should I do for more ponies? Off the line

it has 180k and runs great. Looking for more HP. Been looking at the BBK throttle bodies and the BBK cold air intake as well. Any recommendations on size of the TB? 70, 73? Dont want to have to do a huge tune and I have read with the 73 you don’t have to. It is an automatic tho. Thanks for...

All rear leaf spring hardware was new. New shackles, new bushings, all new bolts spec'd.

The front coils, shocks, rear leafs and shocks are all 1 year old.

Ok, so here are my measurements: Front driver side - 24 3/4 Front passenger side - 24 3/4 Rear driver side - 27 1/8 (27 when I sit in it and get out) Rear Passenger side - 27 1/4 (27 1/2 when I sit in it and get out) (Front does not change once I sit and get out) When I stand behind the rear...

The previous owner did the 5 lug and 8 inch rear. The steering components under the car are still 6cyl.

Another pic... Is this an i6 or V8 spindle?

More pics....

Hello, I am looking to change out my i6 and replace it with a 302..... Here is what has been done: 8 inch rear 5 lug all around The pic is my spindles... Do these need to be changer out? Does the steering components need to be changed also? Anything else? Just looking for a partial daily...

Ok everyone... Need some guidance. I have a 200 66 coupe. Original engine. 95K. Runs good. Original coil with external resistor is currently in place. Looking to change it to a MSD Blaster 2 with ballast resistor. I have a loadomatic distributor. Is this comparable and will it work? Thanks.

Ahhhh. Yes. Ok, I know where this is. Thank you for clairifying.

Ok... Everyone says rear torque boxes..... Where are these?

Again, sorry for the repost but I have done a search to try and find pics but just found threads. Looking to change out leaf springs, front shocks and springs and some linkage on the tranny. I am trying to find the best place to jack up and place stands so I can get under the car. Any pics/...

Ok, as you can see the original leafs have the long shackles which means someone before me did it to compensate for the sag. Now I just ordered a kit from CJ Pony... LSK1 4 leaf. If I install the new leafs with the shackles that come with the kit how much will it raise my ride height? I like the...

Ok. I'm going to change plugs, wires, cap and rotor. Since I am on a budget what can I do to improve performance while keeping the engine stock as it is? I've read going to a DUI set up but that is like $400 plus changing the carb. I have a autolite 1100 1V carb now but I've also read to change...

Ok thanks for the info HWYMAN... Rear shock are new. So I should change out the shackles to standard ones first... Question, why would anyone put extended shackles??? Reposition leaf angle due to being worn out?