Search results

Been quite some time since I've been active on here! Here is a link to my new build a 1999 turbo coyote swap 99 Yote Build

Looking for the best place to pick up a good quality windshield for my 1988

That would make sense to me I put a new clutch setup on the car... no cable went with a hydraulic setup so I'm sure the petal probably went to the floor quite deep with no cable hooked to it at some point... So I will try re-setting the adjuster if I can figure it out...

Yes I used two fuses one for each connector that went into the switch a black one and gray one. Yes I used the fuses because of the fit nicely Well I think I did get it tested right it was in the car... and like you say it's a pain to get under there... To adj the switch what is the...

perfect just did the test switch is bad... Just going to bypass the switch for now until I get a new one... Just used two 20 amp fuses to complete the circuit. Or should I have smaller fuses something like 10 amp's?? Thanks again

Hey guys just wondering the best way to test my cutch safety switch thanks.... Would I un-plug one connector then press the clutch pedal down and test the connection that's un-plugged ? Thanks...

After several attempts to contact this company.... (E-mails & Phone Call) I have to result to asking you guys for some info and help on my install. Has anyone put this kit on there fox body? I've watched all the videos that American Powertrain has posted about this kit. They can be found...

Looking for some info on this part number it's off a set of long tube headers. TSF - 9827992 Thanks

so what i'm getting out of that is that I should be tapping into the dark green/ yellow wire on the computer side of the wiring?? Thanks again..

I wonder if they modified the stock handle or just left it alone?

Last winter I picked up a brand new painless wiring harness for my car, It has a wire for a tach hook up and when I've hooked this wire up to three locations that I figured would be the correct spot to hook it to. When I do this the car will not start it just cranks over and over.. - I've...

thanks :nice:

:nice:

lol :rlaugh:

looking to get a DCC controler, I see the website is down, any special way to access it? Looking for one to control my Mark VIII fan.... really causing cahos with the car at idle.... Welcome to Delta Current Control

Yeah making the changes on the fly with moates quarter horse would be nice, I might make the switch from the TwEECer to moates this winter. And yes Cal/Con Cal/Edit are buggy with not much support, but I do hear that a new version is in the works. If it ever comes out... I went and...

same spot for me!

New Brunswick

Sounds like you have a fun car to drive... I just got done putting on cervinis cobra side skirts on my car 1st show of the year this weekend coming. :nice:

All you guys/gals with your battery mounted in your hatch/trunk... Where do you have your battery grounded to?