Search results

I've been contemplating putting a very low mile mildly built 93 5.0L with a C-4 that I already have, into my DD 95 V6 Mustang, due to the 3.8 having 165k miles on it and knocking above 2800 RPM, and I have a few questions. I know I can wire the engine up w/o too many issues. I'm just not sure...

I've been contemplating putting a very low mile mildly built 93 5.0L with a C-4 that I already have, into my DD 95 V6 Stang, due to the 3.8 having 165k miles on it and knocking above 2800 RPM, and I have a few questions. I know I can wire the engine up w/o too many issues. I'm just not sure what...

Someone needs to help me figure this damn thing out before I burn it to the ground. 95 Mustang 3.8L Auto History... I had been nursing the car along for a while with a seeping radiator sealed with aluma seal. In November it was seeping again, and seemed to take spells where it would run a...

I need to find a source to get the approximate value of an old engine. I have been sitting on a complete, carb to oil pan 460 out of a 68 Lincoln Mark III with roughly 68k miles on it. any help would be appreciated. Thanks in advance.

Does anyone know if a T-5 from 5.0L will bolt onto a 3.8 in a 99 Mustang? Are the input shafts different? Bellhousings are probably different too? Thanks in advance!

A buddy of mine just called and asked me if i knew how to install new reflectors in the rear bumper on his 96. I am ashamed to say i have no clue. he seems to think he needs to pull the cover off to do it, but i have never really looked at them before on my 95, so i am clueless. :shrug: any...

Tips on wetsanding and buffing I need to wetsand and buff out my 95 metallic silver mustang.(Ohio winters have taken their toll on the finish) I have never done this on a clear coat painted car, and was wondering if Y'all had any tips. Thanks!

I need to know if headers for TFS twisted wedge "race" on a 302 in a fox body will also fit a world products head on a 302 in a fox. any ideas? is there a big difference in the exhaust port height that may cause clearance problems? is it a matter of plug angle? (being able to get to the...

All you guys runnin C-4's.... I have a C-4 i am wanting to put in my 84GT. i have long tube MAC headers for 5-speed, and world products iron heads. My question is, can I use the 164 tooth setup? will the bellhousing cause major issues with the header clearance or trans tunnel clearance? I want...

I just picked up an early model c-4 that has been rebuilt, and a 2800 converter with a shift kit...but anyway, what i am wondering is, this is one of those that when the selector is placed in drive, it starts out in 2nd gear. the only way to get "low" first gear is to manually shift it down. i...