Search results

So I bought an aod from a friends friend... anyways I get it home and it just doesnt look like an aod to me, but ive never really had any autos... im 99.999 the bellhousing can unbolt isnt that only on c4's? what is the best way for me to find out what I have.

Trying to look up an old cam im going to use... its a crane cam number is 941681 I know its a huge solid lifter cam.. trying to find out what the recomended push rod/lifter setup to use its somthing like 272/276 640/650 lift but cant remmeber thanks!

can anyone tell me the difference in aod from 94/95 compared to a fox

Im wanting to build a heck of a street car, trying to get some ideas on what way to go.... Here is what my build is going to consist of.. 74 block. .030 over flat top pistons, some unknown aluminum heads 2.02's going to be ported way out. ported victor jr intake with holley 650 dp...

Bought another project car and the guy had no idea what was on his car. The heads are aluminum and there is a CK stamped on one of the ends but the C is backwards any ideas???

Hey guys Cant figure out whats going on. I have 0 mile motor, was assembled by experienced engine builder, fired it up everything was great. once it got warm the oil pressure started dropping to nothing. Pulled the pan bearings are fine no shavings, retorqued everything, tripple chekced...

This is one of my first buff attempts... I started out with very dull nasty looking dead paint. I first sprayed the car down with water than sprayed it with simple green, and scrubbed it with dish soap and warm water... The paint was so dirty it took about an hour of scrubbing to get the...

anyway to make this work and run alright??? what fuel pressure?

Hey guys hoping my car is good for 12's n/a myabe even mid-low 12's hoping for high 10's on nitrous here is my mod list.. 1989 gt vert wait wait might not be as heavy as you think :D Chassis,,, tube k member, tube a-arms full coil over suspension, manual rack, no a/c no nothing just...

Hey guys I think im going to convert to a carb setup.. I am much more familiar with tuning them ect.. really my car is not a daily driver and is more of a weekend/track car.. anyways I have the complete aeromotive system a1000 ect.. can the regulator it comes with go down to 6-7 psi? Also...

Hey guys I have a 89gt and my car is running extremely rich at idle bad enough where my eyes start to water.... anyways fuel pressure is fine I backed it off even and it didnt help.... I have custom gauge cluster so I cant see if the check engine light is on... anyway I can check for codes. any...

Hey guys my car is running extremely rich like make me dizzy driving around rich lol.... anyways what should I be running here are my mods. trick flow stg1 cam ported gt40 heads, coba intake a1000 pump..... yah i know lol aeromotive rails, aeromotive fuel pressure reg 24lb injectors...

Hey guys trying to figure out the noise my engine is making.. It sounds like a rattle/knock but only at around 2k or under partial throttle goes away at WOT i might have to take a video of it to help describe it better... any ideas?

Hey guys recently bought a fox that has the bbk ssi intake on it... never really heard to much about the intake... but it seems ok.. my question is with the weird design I was planning in spraying nitrous through a single fogger in my cai, but i'm wondering if everything is going to distribute...

Hey guys this is my first time installing springs into a sn95 so I have a few questions.... For the fronts Can I just unbolt the shock at the engine bay, and jacks to car up to slide out the spring? Or will I need to pull off the caliper or anything??? last time I did it on a fox body I ripped...

Anyone have stock mufflers but aftermarket everything else? I am tired of the loud exhaust and just want to keep it quiet unless im on it. Also how bad would stock mufflers really hurt me. say against flowmaster or similar

Not sure what im doing wrong. I have a 97 gt.. intake was leaking because it was cracked behind alternator... SO I got a replacement looked fine.... tried to reuse the old gaskets they looked like somoene had previously changed them and looked fine... bolted everything up... starting filling it...

I am curious of how big of shot has been run safely on a stock short block... and how long it lasted you I have a very low mile stock shortblock with forged internals, and hoping to push 200-250 shot and have it last atleast a season... for saftey in thinking wet shot spraying from 3150-5500...

I am trying to decide if I should stick with nitrous or go custom single turbo.... I am looking for mid-low 11's is it possible with this combo???? 306 Trickflow Intake Trickflow stg1 camshaft Ported e7's 1.6 rr's bbk long tubes O/R h pipe with flows walbro 255 w/regulator NX 200 wet...

I'm unsure of my problem but im thinking maybe the maf is heading out.... during light driving it feels like there is a dead spot in the throttle during part throttle form like 2-3500 just feels alittle boggy, And at idle the car seems extremely rich with the windows down it almost gasses me...