Search results

***SOLD*** High impedance, EV-1 style injectors. Recently cleaned and flow tested. Have not been used since they were cleaned. $295 shipped. Thanks, Chris 3163054215

Agree with Boss 351. If the walls look like they are in good shape, a good torque plate hone job will suffice. The longer stroke on the 347 can cause issues, however I believe the newer 347 pistons have the wrist pin set lower in the piston which helps reduce stress on the rings. I purchased a...

Edlebrock RPM II intake with 1" spacer. I also have a Cervini 3" cowl hood.

Headed to the tire store in the morning for new Nittos all the way around. They have set of 315/35R-17's Drag Radials for the rear, but I am not sure they will fit? Currently, I have a set of 285/40-17's installed and every now and again when I turn into a driveway cockeyed you can hear the...

Just got my 331 stroker running. It has approx. 120 miles on it and has an S-Trim installed. During the installation, I put a new aluminum radiator in and went back to the stock fan and clutch with stock fan shroud. Had to do this because the Mark VIII electric fan would not clear the 8-rib...

might really look into this and see if it is worth it. from the few reputable guys i have spoken with, they say the non-intercooler vortech system is the way to go on a stock '05 motor. reason being the computer will be tuned for the engine at optimum settings which usually means when the car is...

I can tell you from experience the Holley Flowtechs for an AOD would not work for me. I fought with the things for almost 2 days before I gave up and went back to BBK 1 & 5/8 shorties...

These are to help evacuate extra pressure (i.e. crankcase) build-up; especially in supercharged applications.

I would agree with this if they were new. Any wear at all, on any drag radial, will result in reduced daily driving performance.

The voltage will help you determine if the plunger is the correct length. If you have replaced both, you most likely will need to "lightly" sand the plunger to the correct length to get it to function properly.