Search results

OK I bought a AFCO Rad, 2 core 27 1/2 inch, Its pretty wide and I really cant fit my shroud back in there because it dosent fit flush agaist the radiator and its hitting the A/C compressor, first do i really need the shroud and secondly I bought a flex fan off some guy for like 5 bucks months...

Hey, Just put a new motor in my car, .030, Ford B-cam, stock heads, intake, basically stock everyhting except for the cam. I have about 30 miles on the motor now, I have a 160 Degree T-stat, the car however is running at about 210-220 when it gets fully warmed up after I drive it for a little...

Hello, quick question, I've searched through soem posts but have not come to a conclusion. I have a simple question, I put in a new king cobra clutch to go with my resurfaced flywheel and new motor, the clutch engages very high off of the floor, maybe an inch and a half from the top of its...

I'm trying to get my motor started for the first time. It'll start but shut down right away. I'm getting spark and fuel pressure. The fuel pump primes but only when I have it in the start position, not in the accessory like it used to. I know this because I turned the key without depressing the...

Ok, I feel dumb but which way does the T-stat face when I re-install it. I forgot to pay attention when I took it out and I searched the forum and looked through my haynes manual and nothing. Does the bridge face towards the front or back of the car. Thanks

I need to clean my lower. It has some silicone and lots of gunk and sludge stuck to it... Any easy way to clean it, like just letting it sit in some sort of cleaning solution then wiping it down? Thanks

Hello, well I'm putting in my new throw out bearing I got with my KC clutch, being the dumbass I am, I forgot to check to see how it was in, dont know if its a big deal or not, but on the TOB, there is a sorta raised bump on the back part the cylinder. Does it matter whether it faces the clutch...

How should I store my cam whlie its not being used, it'll only be for a few weeks but I dont want it to rust out. Will just leaving it in a little oil be OK?

Hello, I have a few questions. I need a new engine and have a few possibilities. One being just to buy a rebuilt from ford which will run me about $1200, or building a fresh motor myself reusing my block and getting new internals. Basically, I'm on a budget and want to do this right the first...

Hello, I've been searching around the site a little bit and been readiing up on lifting out my engine. I've read that I can bolt the lift to the front and back of the heads although I dont seem to have threads on the back of the drivers side head and on the passenger side I have metal coolant...

Hello, does anyone know where I can rent a engine lift for the day from that wont cost me an arm and a leg? or is anyone selling one? Thanks

Hello, I have a 91 GT and I need to disconnect the fuel lines. The Haynes manual showed 2 different fuel line types, push connect and spring lock, I believe i have the spring lock connection but if someone can clear this up for me. Do I need a spring lock coupling tool, or is there another way...