Search results

let me tell you what its doing had the car about 3 weeks now.about once a week,it wants to try and run hot...and the heater stops blowing heat. last week,i changed the themostat..it was a 160 to a new 195.car ran all week long...most it has since we have had it.usually,it tries to act up every...

i have a set of Mach 1's 18x9 on my 1995.whats the biggest tire I could run on the rears.I think I will stick to the 245/40 on front.

1998 has a hum noise at idle and low acceleration.once you ramp on it or even accelerate hard,it goes away.at idle and low rpom's,sounds like a freaking supercharger.it has a K&N air filter.I was wondering if it is the mas air going out?iac?anyone? seems not to effect the driving..just annoying...

we just bought this 95 mustang and it has these rims on it.2 of them have slight blemishes.i really dont like the rims but if we keep them,i want to replace the 2 bad rims. i cant find any info on them.i see the 17 inch ones alot.are the 18's rare?

on the 85(302 AT) my friend owns,when we are going own the road,sometimes i will just jump like it jumps geras real fast...sometimes it shakes. Every once in awhile it will it will act up on start up in first gera klike it wnts to shake then takes of.This oesn't happen every time,but maybe once...

It is time to tke the 302 from a daily driver to a more potent steet car. here is what i have now: It is a 1969 302 Block and cylinder heads, block bored .030 over 9.5:1 flat top hypereutectic pistons Sealed Power cast iron piston rings Edelbrock performer cam shaft and lifters Double...

here is my car Running a 1969 mustang 302 and 84 AOD with shift kit http://www.cardomain.com/ride/2238862 my problem: I put her on the dyno in Atlanta.They got the car up to 3rd gear and let it loose.he asked before hand what RPM to take it to.I told him 5k....never been over 5k...

I have an electric choke on my quest.recently,i have had problems during driving.All of a sudden the car gets where it want to buck and stalls.It will crank right back up but tries to flood a tad.sometimes it takes a minute or so to level out,sometimes i have to drive it and let it buck and...

Anyone know where you can buy chrome or billet pulleys for a 302.I dont want underdrive pulleys.I need the factory style v belt pulleys for the 1969 302 in my car.Actually,I think i found the water pump pulley,the crank pulley is the one i am really needing.

What i have is a 1987 chrysler conquest with a 1969 mustang 302.The voltage regulator i am using is a transpo and it has went bad.I bought a voltage regulator for a 69 mustang and i want to use this since its easier to find. What i need is for someone with a wiring manual to let me know what...