Search results

I am selling my Tci Converter and this converter was refreshed from TCI about 1500 miles ago. It was in a 91 aod mustang , its a 11 inch lockup converter, and stalls at 3200 rpm. Here is the link from summit TCI Auto 433100 - TCI Competition Torque Converters - Overview - SummitRacing.com...

xe 266hr12 - Cam Style Hydraulic roller tappet Basic Operating RPM Range 1,600-5,600 Intake Duration at 050 inch Lift 216 Exhaust Duration at 050 inch Lift 224 Duration at 050 inch Lift 216 int./224 exh. Advertised Intake Duration 266 Advertised Exhaust Duration...

xe266hr12 130 shipped edelbrock 3828 - 70mm tb and spacer - sold Underdrive water and alt pulleys - 30 shipped parts are in OKC OK paypal and ups shipping

Full setup, spectre filter, wiring adapter, Lmaf, cheap plastic tube, 90 bend, and sct chip. Full setup was off of a a9l 331 roush headed car with nitrous. Been sitting in my garage for over 2 years. 110 shipped!!

I have a 1991 gt that will not start. There is no injector pulse (check with noid light) but there is 12 volts at red wire on injector. Fuel pump is not priming when ign is on but will when test connector is grounded. There is 12 volts at the constant pink wire at the fuel pump run and...

Where does a 1994 mustang suck it air from when the air or vents are on?? Every time i stop the car blows exhuast fumes into the car, need to find where the exhuast leak is around.

My question is can i put 1.94 and 1.60 valves in gt40 heads and not have to flycut my pistons. I will clay the pistons and check the ptv, but just wanted to know if i will have problems right off the batt. The heads have at least one bent valve and i am going to put new guides in it and also...

I have a 1994 Cobra that is having problems with the injectors. Car has a real bad idle. No Computer codes and On the Cylinder balance it brings up that the #6 has a problem. All plugs are nice and tan but the 6th plug and it is black. I swapped the injector, reset the computer and re-ran the...

I have a 1994 cobra that has a tm40 in it. My cobra gets about 215 to a tank and i am sure that the computer doesn't like the 24lb injectors. I purchased a used j4j1 on ebay and my car idles and drives better with the tm 40,a lot better. I think the j4j1 was DOA, so my options are...

I have a 94 cobra with 3.73 and stock driveshaft. I have a nasty vibration through the shifter and i can some vibration through the pedals. Vibration is there with clutch in or out and transmission in neutral or in gear. Vibration comes more noticeable with rpm. Tires have been balanced and the...