Search results

Hey everyone. I've a registered user of stangnet for a while, but haven't been on the boards for a long time. What brought me back was I bought my first fox body on Saturday and it has a 86 turbo coupe motor w/ T3/T4 transplanted in it, among other things. I know nothing about fox bodies or...

I'm starting to do some suspension upgrades soon. I've got some lowering springs, CC plates, ball joints, and a bumpsteer kit ready to install. I'm also thinking about doing upper and lower control arms or shocks at the same time, but I don't think I can afford to do both right away. Which...

Hi, I am helping someone install 2001 GT power seats into a 95 GT that had power seats. The problem is that the 2001 driver's seat has a 4-wire harness and the 95 driver's seat wire harness only has two wires. Does anyone know how to wire up the seat to work in a 95?

I've finally gotten moved to Seattle from Iowa, picked out an apartment in West Seattle and started work. I'm looking forward to meeting some fellow stangers up here in the NW.:nice:

I'm supposed to put some silicon gasket maker on the new shifter before I put it on the tranny...what constitutes as silicon gasket maker and where can I buy some if my dad doesn't have some in the basement? Thanks!

Before I put my catback and TB on, my car was definitely rev limited to 5800RPMs...I would hit 5800 and the car was definitely not going any higher than that. Now that I have the catback and TB installed, I gunned it pretty good last night and got it up to 6K RPMS for a brief second and it...

I just got done test driving my car after installing my new 75mm TB/plenum. The install went fairly well, but there were a few hiccups. We couldn't get a measure on the TPS voltage with the key turned on, so we measured the resistance at idle with the TPS disconnected and matched that on the...

My TB/plenum came in today, checked it out just to make sure everything is in order. I've got a Haynes manual and I've been reading over the swap instructions to make sure I know what I'm doing before I do it, but was curious if anyone else had any helpful tips. Also, it came with two...

Out and about this weekend with some friends, designated driver. We were leaving the club as a 1993 Grand Marquis pulls into the lot with 22" spinners and a mean sounding exhaust. Went up to the guy and asked him what he had done to his car. He said just the spinners and Flowmaster 40s. I...

I was at a bar the other night and I met a girl who said she also drives a Mustang. I was asking her about her car a little bit and she said it was a 1995 Mustang Coupe Special Edition with a V6. The "Special Edition" threw me off a little bit, I hadn't heard of that before. I went to her...

I posted earlier trying to figure out what to do next with my 01 GT. I ended up getting a K & N Filtercharger because I could run out to my local auto parts store and install it in 5 minutes. I'm thinking next I'll get an Accufab 75mm TB with Accufab plenum. However, I'm still thinking...

I've been trying to figure out what mod to do next my 01 GT (not that I've done a whole lot to it anyway -see sig), and I'd like to go with something for performance rather than appearance. I'm a poor college student so I don't have a lot of money (going to have to stay n/a for now). I'm...

First of all, I don't consider myself to be an expert on cars in general by any means, but I probably know enough to be a little dangerous. :bang: As I understand, back in the hey day of muscle cars (before we became really concerned about pollution and then ricer sport compacts came out)...