Search results

Here it is.

This makes sense to me. Since I couldn't see where the hose attached back into the block, I didn't know how it worked. Thanks!

I have a '98 4.6L SVT engine in my Panoz Roadster and I'm gutting the A/C - Heater unit and replacing it with a Vintage Air Heater only. I am looking at the heater hoses and am told that the supply hose into the heater should be the one that is connected to the tube that runs under the intake...

Thanks - I'll remember this if that THEFT code ever comes back. Actually, my engine is an SVT crate engine that has the proper Ford ECU, wiring harness, PATS module, etc. Thanks

All's Well!! Well, before I was ready to ask for the wiring diagram and get a new bottle of gin, I decided to reflash my chip. for over a year I've been running with a custom tune I made with Sniper Performance software. I did recently install a new battery, and I wanted to check to see if...

Thanks again. Boy, I think I'm getting a headache.

Thanks for taking the time to create all the info in your messages! It looks like my problem is: " The anti-theft system does not operate correctly — the vehicle starts but flashes a fault code on the theft indicator at key on Incorrect PCM calibration GO to Pinpoint Test C . "...

I found the PATS module and it has a lot of wires coming into it an out of it, so tracing down continuity in each wire doesn't look like a reasonable option. I originally thought that location of the PATS would be in the rear of the car and maybe I accidentally nicked a wire in a harness I...

Thanks for responding guys. I went back in the garage and restarted the car and watched the blinking more closely. After about a minute, it started blinking once with a pause followed by 6 blinks in rapid succession ( 1 + 6 ). Remember that the engine runs fine throughout all of this. I...

I have a '98 Panoz Roadster which has a '97 SVT engine and running gear, etc. It just started flashing THEFT on the dash. Car runs fine. Theft continually blinks fast and does not stop. Tried all 3 keys - same response. I will run the codes next weekend when the weather is better, but...

Has anyone upgraded their clutch and brake pedal box to AP or Wilwood or other? I'd like to change mine to get a more solid feel. Any suggestions would be appreciated. I'd like to find something that bolts in as much as possible to avoid tons of fab work. Thanks

Do I need 2 Oil Catch Cans? Ok, so is the best set-up to use 2 Oil Catch Cans? One for each side of the engine?