Search results

Alright guys I am ready to start assembly of my shortblock that had a cracked piston and just basically shot bottom end.. I am going with a flat top pistons with valve reliefs. I am using World Products windsor Sr heads. 200's. Ported cobra lower and stock cobra upper, and all the usuall bolt...

Hey guys, i have been havin a noise problem from my 89 coupe since i bought it.. Well i pulled rocker arms off and the pushrods out and soon noticed a problem one pushrod was stock length and all the others were longer!! WTF. Also all the long ones were slightly bent and the stock one was fine...

hey guys i just bought an 89 lx with a 306 with roush 200 heads and a 526/532 lunati cam. My question is that the roller rockers are very noisy so I pulled the valve covers to check and see whats going on, and well i found the following. The car has Erson 1.6 roller rockers, guide plates and...

I have an 03' GT with several mods, including a P-51 intake which I just installed last week. My question is that the car runs great going down the road and at wot but at idle I hear a huming noise coming from the center of the intake. The car Idles a little high and hangs a bit until I take the...

I have a 03 gt with 61k on it, my problem is that the ses light is on for a cam sensor bank 1. I have replaced the sensor and it is still on. The car runs and drive great but sometimes when you start it, it will go dead or backfire through the exhaust and go dead. The car has pulleys,cai,intake...