Search results

give me your email and i will send u some pics

bump

302 bored .30over. 5spd. Canfield heads port&polished, lunati custom cam, comp cams beehive springs 1.6 roller rockers, Edelbrock Victor JR. intake port matched to heads. JE flat top pistons, eagle connecting rods, 650 speed demon carb. melling high vol oil pump, Edelbrock high flow water pump...

ok heres my problem, after my car gets warmed up it runs fine but if you shut it off and start it right back up it runs like crap sounds like its not running on all 8. if you let it sit for a few minutes it runs fine. i have a 650 speed demon on it and a crane cams ignition box and street/race...

anyone :shrug:

I have a 650 speed demon on my car, the problem is that when i first start it up it doesnt want to run. it pops through the carb and you have to keep pedling it to keep it going. after it gets to operating temp it idles and runs fine, but if you let it sit for about an hour it does the...

I also have the crane dizzy and crane HI-6 box in my car and i like it. Had a msd setup in it before, after the box took a crap twice i put the crane setup in. MSD has gone to crap.

yes sir

it wasnt that hard to install comes with quick disconnects plugs so you dont have to cut any wires if you have to remove it. i went through 2 msd boxes and decided to switch

crane cams has a good ignition setup also. thats what i have in my car

yep im from leesburg

lamotta performance in longwood has a dyno

I have a msd blaster 3 coil on my car and it is shooting a spark out the negetive side of the tower and arching to the negetive post on the coil. i just put in a new msd 6al box because the old one died. it started doing this after i put the new box in didnt do it before with the old box. i...

you could have a bad ground or a bad ignition box. same thing happened to me bothered my for a week and found out it was my msd ignition box going bad

I have a msd dizzy and a blaster 3 coil with a 6al ignition box

My question is i just got my new motor in my car and started it up today it will run for a few minutes then it just shuts off. it has a carb on it i cracked the fuel line to make sure no air is in the line. once it shuts off you can start it right back then it does the same thing after a few...

your shocks could be bad. i had wheel hop too i changed out my shocks and it went away

just curious if you guys know of a good set of plugs for canfield heads. Looking for a set for my heads. Thanks, Dan

I would build a motor you can have your block bored .30 over and buy a roatating assembly from CHP,DSS, or keith craft. Ive heard some bad things about dss used to be good but they seem to gone down hill. I'd do some researching before you go buy something. also if your looking to get heads and...

anybody else have an idea