Search results

  1. A

    Engine rattle

    how many miles do you have.... maybe theres a crack in your flywheel
  2. A

    Brake lights not working

    bring ur car to al maroone ford 4045 transit road williamsville ny, i'll fix it for ya i got nothin else to do, ask for Alex
  3. A

    What size rim/tires r on Cobra 03/04??

    try www.discounttiredirect.com for tires they have realy good prices
  4. A

    T/O bearing issues:Please read and respond!

    my gt had the same problem at just under 14K when i first got it. By pumping the clutch the sound would go away. After i started driving the car real hard the sound disapeared and hasn't returned, since then i've almost doubled the HP and it hasn't broken so i wouldn't replace it until it goes
  5. A

    M.I.L eliminator necessary?

    Only vehicles equiped with OBDII (96-up) require MIL eliminators because they have O2 sensors after the cats. Most likely the cause of your 88's check engine light is a bad primary O2 sensor.
  6. A

    My Mach1 Grill Delete has gaps! *pic*

    if you want your grill delete to sit flush with the front bumper cut off small sections of vacume hose and slide them over the screws that hold the delete peice to the bumper, the hose acts like a spacer to take up the gap, i don't know if this will work for the sides but it works for the...
  7. A

    03/04 cobra rear bumper owners: painting question?

    ur question would be best answered by a body shop... i think if the texture peice were painted it would become smooth, hope this helps
  8. A

    HELP Gas LEAK!

    if u decide to do so, when your dropping the tank make sure not to break off and lines or wires running to the tank... its a good idea to lower it a little and disconnect everything... the less gas you have in the tank the easier it will be to mount back up, i've done a lot of gas tanks and...
  9. A

    Forged Engine Buildup for Kenne Bell 2.2

    before you build ur motor i suggest u read sean hyland's book How To Build Max-Performance 4.6-Liter FORD ENGINES in the book they suggest using flat top pistons, because the low compression would make the motor sluggish, they also say a positive displacement supercharger is more prone to...
  10. A

    Help I need info on 4.6 DOHC

    the 99 cobra parts should interchange
  11. A

    Gears and speedometer questions..

    ur speedo will probably be off by about 20-30mph... i rode in an uncalibrated mustang with 4:10s once and at about 40mph it was showing 90mph
  12. A

    wheel bearing noise, or rear end??

    if your noise is specific to the right or the left then its most likely a wheel bearing otherwise it might be your carrier, a wheel bearing is supereasy to replace, and a bearing rebuild kit(from ford) for the carrier is only about $63 if i'm not mistaken
  13. A

    SVT newbie..what do you think about these mods

    as long as u tune the air fuel ratio correctly... i think magnaflow makes a catless mid-pipe
  14. A

    SVT newbie..what do you think about these mods

    for 96 and up vehicles a programmer is used instead of a chip, it doesn't really matter which tuner u buy, it all depends who pre programmed it, unless u wanna tune it yourself... the sct xcalibrator offers the widest range of tuning( i have the xcalibrator for my S/C gt, programmed by modular...