Search results

  1. M

    carb'd parts

    Lokar throttle cable and lokar AOD tv cable for carb'd foxbody. Also a breeze automotive fuel pick up(replaces stock EFI hanger and pump) for a carb'd fox body.
  2. M

    '93 cobra computer

    '93 cobra computer for sale. Must use #24 injectors and a '93 cobra mass air meter.
  3. M

    Trick Flow Iron Heads???

    Yeah, they weigh a ton.lol I'm thinkin' about runnin' them on a .040 302 until I get my 351w built... I Know it's probaly overkill for a non stroked 302, but I jus wanna run them on the 302, until the 351 is done, then put them on the 351... Does anyone make headers for these heads? Whats...
  4. M

    Trick Flow Iron Heads???

    I jus recently got a set of heads that I was told were 'trick flow high port heads'. I tried doin' a search on them, but I really couldn't come up with too much info on them... Does anyone know how to tell what the really are and does anyone have any specs on them? I know they require special...
  5. M

    Possible wiring problems???

    I have a '92 mustang that use to be a 4cylinder, but was converted to a 5.0 using an '88 HO motor and a '91 harness. The problem with the car is that it is not running on the #1 cylinder (it has a dead miss at any rpm). I did a compression check and that turned out good, checked to see if the...
  6. M

    Steel bearing retainer?

    ??? It turns out that ford has discontinued it.... I guess i'll have to by the one from hanlon motorsports, but which one would be the same as the 4cyl? I'm guessin' the one for the 4cyl. turbo would be the one, but I would hate to but another retainer and it not work. Thanks for the help!
  7. M

    Steel bearing retainer?

    Does anyone know of any companies that make a steel bearing retainer for the 4 cylinder trans? If not, I guess i'll have to go to ford and get a stock replacement.... Does anyone know how much a stock one from ford usually goes for?
  8. M

    Which bearing retainer?

    Looks like i'll have to get a POS stock replacement one then....
  9. M

    Which bearing retainer?

    I'm in the process of converting my 93' lx from an automatic to 5 speed. I found a transmission at a local junkyard in which I pulled out of a '90 2.3l mustang. Anyways I had already ordered a steel bearing retainer from JEGS thinking it would work, needless to say when I took the old bearing...
  10. M

    U/D pulleys on a std. rotation setup?

    I was wondering if you can run U/D pulleys on a standard rotation water pump set-up? The reason i'm asking is, because i have a '93 mustang that I converted to V8, but I used a '87 crown vic motor which has the std. rotation water pump and has the alternator on the drivers side. Will it throw...
Top Bottom
Back
Forums
Menu