03 dyno numbers HELP

Discussion in 'SVT Talk' started by gtstangrunner, Sep 5, 2005.

  1. gtstangrunner New Member

    Member Since:
    Sep 21, 2004
    Message Count:
    58
    Likes Received:
    0
    Trophy Points:
    0
    Well I went to a Mustang Show here in Ohio and put my baby on the dyno 80 dollars for 3 pulls. She made 438 lbft torque :D and only 371 HP :nonono: . My power is dropping off at 5000 so I think I need a good tune on the dyno. My mods are SLP catback, BBK O/R Xpipe, 12psi and K&N FIPK. I have the Predator tuner and installed the pulley tune so not sure why the HP was so low :shrug: . I appreciate the feedback fellas and fellets.
  2. mkkrs1 New Member

    Member Since:
    Dec 2, 2004
    Message Count:
    49
    Likes Received:
    0
    Trophy Points:
    0
    your tq looks right, hp is low. was the engine temp very hot before the run. I have simliar mods and made 447hp 462tq at 88deg F 29.42in-hg 48%humidity
  3. Uncle Meat Banned

    Member Since:
    Jun 13, 2002
    Message Count:
    3,869
    Likes Received:
    0
    Trophy Points:
    0
    CUSTOM TUNE ASAP! You should be making a lot more HP than that. The stock Predator Pulley tune leaves A LOT left on the table and is just good enough to get you to a dyno where you can then have a professional tune it correctly. I highly recommend James from RWTD Running With The Devil (www.runninwiththedevil.com) He can email you a tune for your predator that should get you to at least 450RWHP.

    U.M.
  4. Linn@Amazon New Member

    Member Since:
    Sep 8, 2005
    Message Count:
    1
    Likes Received:
    0
    Trophy Points:
    0
    you will benefit from a custom tune for your Preditor..some cars seem to do OK with the boxed Preditors tunes but mostly everyone ends up with a custom tune..
    getting a custom dynotune from a reputable tuner is always a good option but not one that is available to everyone.. next best is a mail order program from a knowledgeable and expereinced 03 Cobra tuner.
  5. Uncle Meat Banned

    Member Since:
    Jun 13, 2002
    Message Count:
    3,869
    Likes Received:
    0
    Trophy Points:
    0
    I bet Linn knows where you could get a good mail order tune too! :nice:

    U.M.
  6. Friedchicken Founding Member

    Member Since:
    Mar 13, 2002
    Message Count:
    497
    Likes Received:
    0
    Trophy Points:
    0
    Sounds like you were spinning on the dyno. You sure he strapped th car down tight?
  7. Linn@Amazon New Member

    Member Since:
    Sep 8, 2005
    Message Count:
    1
    Likes Received:
    0
    Trophy Points:
    0
    do you know what type of dyno it was.. I know Castrol sponsers a portable Mustang dyno at alot of the race events we go to..it is posible that you are spinning but I know we saw a drop in HP and boost with an O/R pipe on our 03 cobra..when we put the cats back on it gained it back..it is hard to say for sure what could be the problem without any data. did you get a graph
  8. SVT32VDOHC waiting for the next hack atta

    Member Since:
    Nov 23, 2001
    Message Count:
    4,412
    Likes Received:
    0
    Trophy Points:
    0
    Prolly in the tune, but some dyno are mustang dynos which put a load on the car, which is more realistic than a dyno jet. Your car will put out less on those dynos than a regular dyno jet. I doubt you were spinning, or else they would have corrected that right away, that would be dangerous!! How does the car feel on thetrack or the street?
  9. SVT98Snake New Member

    Member Since:
    Apr 15, 2005
    Message Count:
    262
    Likes Received:
    0
    Trophy Points:
    0
    Belt slippage is another thing.

    That happened to me. I hit 477 rwtq and only 425 rwhp. When I looked at the sheet I could see where it fell flat. Torque peaks earlier too.

    I doubt the tires are spinning, not enough torque for that. These things hold 1200 hp cars.
  10. gtstangrunner New Member

    Member Since:
    Sep 21, 2004
    Message Count:
    58
    Likes Received:
    0
    Trophy Points:
    0
    I went to get my custom tune on a Mustang Dyno by ED at ASAP in PA. and made 370HP and 370TQ. Not too bad for the old Mustang Dyno. Dyno jet would prolly read well over 400 for both. The tune was all out of whack and you know my curves drop out a bit at times and the torque is coming in at like 3200rpm, which i feel is a little early so I might have belt slippage b/c i did not get the idlers yet. I like the belt cover for some reason :rlaugh: . The car feels strong thanks for the advie guys.

Share This Page