08 Bullitt...not that impressive

Discussion in '94-95 Talk' started by earleys94gt, Jan 21, 2008.

  1. earleys94gt Member

    Member Since:
    Aug 31, 2003
    Message Count:
    829
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Ashley, Ohio
    Just wanted to share that our dealership just got an 08 Bullitt.

    I was very interested to see what Ford did for this go round of the Bullitt.

    I must say I was dissappointed...

    Firstly, the car stickers at 32, 1xx. And the Bullitt package is a 3200 option.

    Granted with that package you get interior pieces like a diamond plate looking dash , 373's, 18in wheels, and "baffled" exhaust tips.

    The seats seem more "plush" that a normal GT, the steering wheel is similar to a GT500, a cold-air kit, strut bar w/ serial #, and HID's round the car out pretty much.

    I knew the car wasn't going to be something absoutly amazing, but I think Ford could have done so much better. Was this Ford's plan all along, or did they just not committ that much from the start?
  2. gtstang86 New Member

    Member Since:
    May 8, 2006
    Message Count:
    55
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    California
    i dont think they all that bad. they look good and are quick too. they run almost a second quicker than the dodge charger on the 1/4 too.
  3. 5spd GT "the 5.0 owns all"

    Member Since:
    Aug 7, 2002
    Message Count:
    9,557
    Likes Received:
    0
    Trophy Points:
    76
    Location:
    Arkansas
    Sounds interesting...

    Post some pics:)
  4. Pokageek Active Member

    Member Since:
    Jun 11, 2005
    Message Count:
    2,906
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    MA, USA
    They did more than that. The car rev's higher than the normal GT and has engine enhancements that make the car respond better throughout the RPM range. It is greatly limited in traction at the tires. If anything Ford should have put better grip on it and it really smokes.
  5. earleys94gt Member

    Member Since:
    Aug 31, 2003
    Message Count:
    829
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Ashley, Ohio
    The tires are the same width as a normal GT; 235's.

    Here's a web-site; all my pics were on my cellphone camera.
    http://www.fordvehicles.com/mustangbullitt/?searchid=426441|23362018|172363785

    Pokageek, I was getting at how the internet/press hype was high, and then seeing it in real life it just wasn't what I expected.
  6. Pokageek Active Member

    Member Since:
    Jun 11, 2005
    Message Count:
    2,906
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    MA, USA

    Ahh. Well I haven't seen it in person or really seen any of the press but the true test might be to drive it and then decide. I understand it really is a lot different to drive it. forgot to mention the sound is supossed to be a lot different too. I hear ya though. I will check ut your pics. Thanks for posting them!

    p.s. I bet they don't just let anyone test drive it either ..like it is some sort of queen ,lol. (not to be confused with McQueen -lol)
  7. SublimeRT Member

    Member Since:
    Jan 25, 2003
    Message Count:
    231
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Clarksville, TN
    I really like the new Bullitt actually. I like how plain it looks. I have to say though, I do like the '01 Bullitt better, but I think the 99-04 Mustangs are the best looking ones since the 69-70s.
  8. ProKiller Founding Member

    Member Since:
    Apr 26, 2002
    Message Count:
    2,939
    Likes Received:
    1
    Trophy Points:
    58
    Location:
    PA
    i'll wait till they make a mach 1 again.
  9. ga94gt New Member

    Member Since:
    May 18, 2007
    Message Count:
    139
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Ringgold GA
    +1 I love the look of the Mach 1, IMO they just need to get rid of the s197 body style.:puke: The only one I have seen that looks good is the Super Snake.
  10. Blackened302 New Member

    Member Since:
    Jul 21, 2005
    Message Count:
    1,477
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    McAllen, South TX
    saw one in person a couple weeks ago.. it was nice (as most new cars are) but i don't think i'd spend the extra cash on it.

    i agree--more of a fan of the new-edge bullitt.
  11. Car Nut Founding Member

    Member Since:
    Jul 6, 2000
    Message Count:
    1,177
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Snellville, Georgia (Atlanta area)
    The S197 stangs just haven't grown on me yet, except for the Super Snake and KR.

    Not enough to sway me from liking the 03/04 Cobra which can be had for low to mid $20Ks and many at under 30K miles. Heck, I still can't make the decision to replace my 94 stang, because I'm totally satisfied with the handling/ride/braking, plus another $10K on a new N/A motor will probably give me more power/fun than a new stang.

    As with the 01 Bullitt, this new Bullitt is about the same: better than a GT to some degree, more badging, but still missing something (maybe a better wheel/tire combo)? Just not my thing, I guess. The Mach 1 was cool, but only the 03/04 Cobra was enough of a distraction to cause me to think twice about selling my stang. I like doing mods here and there a little at a time, but a new car would kill that.

    Too bad the Roush 427R stang is a bit pricey. Really nice from what I've read.
  12. earleys94gt Member

    Member Since:
    Aug 31, 2003
    Message Count:
    829
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Ashley, Ohio
    I got to drive the car for a few miles today, and it doesn't run bad with the 3.73's.

    I did also find out it's rated at 319 hp.

    Maybe it's just me, but I think the Bullitt needs something like 340-350 hp.

    Just to set it apart from the others like the stock GT's and Shelby GT's.
  13. 95BlueStallion Active Member

    Member Since:
    Feb 23, 2007
    Message Count:
    1,000
    Likes Received:
    6
    Trophy Points:
    38
    Location:
    Cedar Rapids, Iowa
    I agree, cause you can throw a cheap cold air kit and axle back exhaust to get the few extra ponies and sound that they advertise in the bullitt... It has the style, obviously, of the old school bullitt, but needs more go!
  14. '66 coupe Founding Member

    Member Since:
    Aug 7, 2000
    Message Count:
    1,677
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Lakeland, Fl.
    I'm going to be looking at used C6 Corvettes if Ford doesn't get their crap together with new Mustangs.
  15. DDSTANG94 New Member

    Member Since:
    Dec 9, 2006
    Message Count:
    467
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    FRASER, MICHIGAN
    well, u better just get the vette then, because a 30 thousand dollar stang will never be on the same level as a 65 thousand dollar vette..never...cant even Begin to compare a gt vs a c6
  16. '66 coupe Founding Member

    Member Since:
    Aug 7, 2000
    Message Count:
    1,677
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Lakeland, Fl.
    It's not comparing the cars to each other, but finding the value in the product and whether or not the price is worth it.

    Sure the Mustang is the cheaper car, so naturally you can't expect it to perform as well. But IMO, it should be cheaper than it is. All the dealers by me order up their GT coupes with so many options they're pushing $30K. Sorry, but if brushed aluminum interior panels don't make the car go faster, they better S my D or else they're not worth $800 or whatever Ford charges.
  17. sl03gt New Member

    Member Since:
    Sep 29, 2003
    Message Count:
    182
    Likes Received:
    0
    Trophy Points:
    0
    Has GT500 internals in the rear end.
  18. fox1x New Member

    Member Since:
    Oct 3, 2005
    Message Count:
    164
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Northwest Ohio
  19. Touring23 Founding Member

    Member Since:
    Dec 30, 2001
    Message Count:
    295
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Washington
    Just out of curiousity, which permutation of the 4.6 is in this 08 Bullitt; is it the 4-valve head and iron block, or blower on a 3-valve head, 2-valve head on an aluminum block, or............? :crazy:
    (And does it have the variable cam timing?)
  20. NotQuik Founding Member

    Member Since:
    Oct 21, 2000
    Message Count:
    5,185
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Central Florida
    n/a 3v 4.6 just a couple small additions over the stock gt. They are rated at 315 i beleive though.

Share This Page