If anyone is interested let me know. We run on a dynojet. $60 gets you three pulls with a sniffer. I can't wait to see what she puts down blown! How can you beat $60 for 3 dyno pulls?! :SNSign:
Come to CO where Dyno days are actually discounted runs... 30-35 bucks for 3 pulls depending on the shop and the ammount of people we bring. 60 bucks is more than most of the local dynos charge when you're by yourself. I'm usre its all relative to the local economy though.
$30 for 3 pulls with a/f? That's insane. However, our dyno day we ususally only get 5-8 cars out and it's more of a chill session that slamming cars on and off the rollers. $60 for the tri-state area is cheap from what I've seen!
is that with or w/o A/F ? Dynospeed in Memphis was doing 3/$50 with A/F for August, wish I couldve made it over there.
yeah with A/F and we usually have at least 10 cars & a BBQ and everything. I wanna say its 45-50 bucks at at least 2 of the local Dynos for 3 pulls without a group.
Thats what the dodge supercenter charges me . Its like $65 but for 2 pulls with A/F. Although last time the guy threw in another pull for free
When you guys say $65 for 3 pulls with a/f, what exactly does that mean? Does that mean they tune your a/f ratio across the rpm band during those 3 runs? Or they just give you a reading of it? How much does a dyno-tune cost? or is this what you're all talking about?
hmmm.... we just got one in town here and for the opening special it was $65 per 1/2 hr. (1 pull) not sure about the a/f though... This is the only one in the province though... they can charge whatever they want.
3 pulls with a/f means you can make 3 seperate pulls and they will give you a reading of your air to fuel ratio so you know how rich or lean your car is. With a blower you want to be more rich than lean. N/A you can lean the hell out of it until you hear detonation then just back down your timing. So it's all based off your application really. Dyno tunes normally run a couple hundred.
I'll take it I won't have any fellow stangers there? Fine, leave it up to me to show all the imports how to put down big numbers
we had a stang dyno day here in austin a while back and the shop charged $25 for 3 pulls w/ A/F ratio. i helped the owner push cars before and i got the pulls for free!
227/268 on a mustang dyno w/ x pipe and gears only. i tell people it was stock since i figure the 4.10s cancel out the x pipe
