Bent axle?

Discussion in 'SN95 4.6L Mustang Tech' started by merc123, Nov 8, 2004.

  1. merc123 Active Member

    Member Since:
    Jan 27, 2003
    Message Count:
    1,975
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    North GA
    Today I experienced a problem when backing up. I began backing up and turning to the right. It felt as if the car was bouncing like it had an unbalanced or egg shaped wheel on the rear passenger side. Could it be a bent axle or something? Also, it only happen @ my g/f's apartment in that one parking spot and only when backing out of it. Any ideas?
    merc123, Nov 8, 2004
    #1

  2. merc123 Active Member

    Member Since:
    Jan 27, 2003
    Message Count:
    1,975
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    North GA
    ...
    merc123, Nov 8, 2004
    #2


    Sponsored Ad

  3. Magius231 Founding Member

    Member Since:
    Sep 12, 2002
    Message Count:
    64
    Likes Received:
    0
    Trophy Points:
    6
    Location:
    Rock Hill, SC
    if the only time you can get it to happen is on one spot of some driveway somewhere, the problem isn't with your car its with that section of pavement...
    Magius231, Nov 8, 2004
    #3

  4. BanginStang97GT Founding Member

    Member Since:
    Sep 10, 2001
    Message Count:
    1,037
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Jersey
    Mine does it when backing up too once in a while. But it's my control arm bushings binding up.
    BanginStang97GT, Nov 8, 2004
    #4

  5. merc123 Active Member

    Member Since:
    Jan 27, 2003
    Message Count:
    1,975
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    North GA

    Is it considered normal or could this be a problem eventually? Read: should I get it fixed now under warranty?

    Where are the bushings? At the end of the CA's?
    merc123, Nov 8, 2004
    #5

Share This Page