Brakes Question, Please Help!

Discussion in 'SVT Forum' started by 98KOBRA, Jul 11, 2003.

  1. 98KOBRA New Member

    Member Since:
    Jun 11, 2003
    Message Count:
    14
    Likes Received:
    0
    Trophy Points:
    0
    Well to make a long story short I purchased a complete set of the Baer Eradispeed+ Rotors and eventually wanted to purchase the 4 piston calipers too. When I went to install the rotors the RR caliper was trashed and needed to be replaced so I thought hey i will bite the bullitt now and just go buy the calipers. Well little did I know they dont sell calipers seperatly. You have to buy the whole kit. So basically I need some help. I dont know what to do. Do I just go buy a stock caliper and use them or does anyone know of a company that makes performance calipers that will work OEM sized rotors? I have seen aftermarket cobra calipers that were painted all nice but I dont remeber where I saw them. Please Help. Thanks in advance.
    Sorry it wasnt short
    98KOBRA, Jul 11, 2003
    #1

  2. Lazer2KGT Founding Member

    Member Since:
    Jan 9, 2002
    Message Count:
    1,275
    Likes Received:
    0
    Trophy Points:
    0
    Try www.diskbrakesrus.com The Bear brakes calipers (13" rotor) are the same as the Cobra/Bullitt.
    Scott
    Lazer2KGT, Jul 12, 2003
    #2

  3. pbr brakes New Member

    Member Since:
    Feb 4, 2004
    Message Count:
    3
    Likes Received:
    0
    Trophy Points:
    0
    I work at the company that makes all Mustang brake calpiers. We make Cobra calipers on Red or anodized Black. I can buy all I want at a deal because I make them all day long & we throw away thousands of calipers daily...whole units ready to install...brake pads, shims, bleeder screw the whole nine yards.....
    pbr brakes, Feb 4, 2004
    #3

Share This Page