Well, I am so close to finishing the install of my new MAC longtubes and Prochamber..it is not even funny. I have made it through some crazy hidden bolts(third one in the starter is a douzy!) Steering rod was a royal P.I.T.A but there is a bolt on the passenger side header that sits between the motor mount bracket and the bottom of the header. I have stood on my head trying to get this off but to no avail. I can get a socket on it but there isn't enough room for a wrench or swivel joint w/extension to make it work. Everything else is good to go but with my car in pieces in the garage....its driving me crazy. Any advice would be greatly appreciated. I have an appointment for a dyno tune tomorrow at 10 and would like to make it
Did you raise the motor at all? I read that the JBA headers required you to unbolt the engine mounts and raise the engine an inch. When you get it up and running I'm dying to hear a sound clip. I've been searching forever for a sound clip of longtube headers and a prochamber.
