i can not get my car to run because there is no spark going to the ignition coil. I dont know what isnt wired right...but somthing isnt. Im not even really 100%sure that that computer is getting power to it. I am putting an 87 TC wiring harness in my 86 stang and it is a 'Kiss Me''Kiss Me''Kiss Me''Kiss Me''Kiss Me''Kiss Me'! I am so frusterated with this thing!! anybody know where i can find full schematics for my cars??? and do i need any of the 4 computers out of the trunk of the tc? or are they all abs and ride controll?? help!!!!!!!!!!!!!!!!!!!!!!!!!!
I assume you are going to Turbo it correct?.... You aren't giving us very much info.... If so you need the main ECC computer only from the TC. Go to Stingers or Crovax web sites and look at their wiring diagrams. The ECC harness in these Fords can be used as standalone units so basically all you should need is power and ground. I think you would better off pulling a ECC harness from a 87 to 90 Mustang since there will be less wires to deal with and more people will be able to help you because they are more familiar with that harness than the TC's. Theres alot of junk in the TC harness that you will not be using. Give us a little more info about you final goal. This will help us steer you in the right direction. Mike
