Installed new Metco Fuel Rail kit

Discussion in '2005 - 2009 Specific Tech' started by HEAVYGT, Mar 13, 2007.

  1. HEAVYGT New Member

    Member Since:
    Sep 14, 2006
    Message Count:
    243
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Elgin, IL.
    Installed over the weekend...a little bling...chrome valve covers next.

    [IMG]
    [IMG]
    [IMG]
    HEAVYGT, Mar 13, 2007
    #1

  2. ShowYa06 New Member

    Member Since:
    Jul 3, 2006
    Message Count:
    148
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Kansas City, MO
    I like it! The valve covers will fit right in there!
    ShowYa06, Mar 13, 2007
    #2

  3. StonePony New Member

    Member Since:
    Jan 10, 2006
    Message Count:
    218
    Likes Received:
    0
    Trophy Points:
    0
    What was the purpose? Just for looks? No performance gain from those and not required for your mods.
    Stock rails should be good on any naturally aspirated motor and good until about 600 HP on a forced induction motor.
    StonePony, Mar 13, 2007
    #3

  4. HEAVYGT New Member

    Member Since:
    Sep 14, 2006
    Message Count:
    243
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Elgin, IL.
    When I wrote "bling" exactly what didn't you understand? :shrug:
    HEAVYGT, Mar 14, 2007
    #4

  5. bigcat start with the upper hole, and if more traction is

    Member Since:
    May 2, 2005
    Message Count:
    4,250
    Likes Received:
    2
    Trophy Points:
    78
    Location:
    7200 feet
    where is the tech? this thread needs tech to be in the tech forum.
    bigcat, Mar 15, 2007
    #5

Share This Page