Is the PHP Intake Spacer worth getting

Discussion in 'SVT Forum' started by 01TrueBlueCobra, Jan 3, 2005.

  1. 01TrueBlueCobra New Member

    Member Since:
    Feb 17, 2004
    Message Count:
    361
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    somewhere
    I was thinking about getting a PHP intake spacer for my next mod. Is it worth it, will I feel any gains or see any gains on the dyno.
    01TrueBlueCobra, Jan 3, 2005
    #1

  2. Beau Founding Member

    Member Since:
    Jan 29, 2000
    Message Count:
    3,406
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    San Diego
    no
    Beau, Jan 3, 2005
    #2

  3. 5.0's 4 ever The #1 Stunna

    Member Since:
    Jan 22, 2000
    Message Count:
    5,833
    Likes Received:
    0
    Trophy Points:
    76
    Location:
    Orlando, FL
    I have one on my 96 and felt a gain in lowend of the powerband. I do not have any before and after dyno results but the from the results I have seen on the mach 1 forums its seems to make a decent increase in torque. When it comes to a 4.6 I will take any increase in lowend torque I can get.
    5.0's 4 ever, Jan 3, 2005
    #3

  4. DoubleONegative Active Member

    Member Since:
    Jun 30, 2003
    Message Count:
    1,641
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Hudson Valley
    I had one on my 01 and lemmie tell ya........IT'S A POS!!!!! i lost 5rwhp accross the power band and 1 rwhp at peak. along with an equal amount of RWTQ. i did however gain both HP and TQ from 6500-7000.

    Another note the car ran absolutely ****ty with it on. it ran rough and backfired alot. took it off and it ran fine again.

    I would save your 75 bucks. then again with your mods it may help but i don't know. in anycase it only take 20 mins to put it on

    mike
    DoubleONegative, Jan 3, 2005
    #4

Share This Page