Long Tube Headers: Where to put WB O2 sensor?

Discussion in '94-95 5.0 Tuning' started by DJHA90, Apr 25, 2006.

  1. DJHA90 New Member

    Member Since:
    Dec 18, 2002
    Message Count:
    594
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Texas
    Ive got ceramic coated long tube headers. Should I install the O2 bung in the 1st part of the h-pipe, or go ahead and have it installed in the collector of the header?

    Thanks
    DJHA90, Apr 25, 2006
    #1

  2. zenboy99 Founding Member

    Member Since:
    May 12, 2002
    Message Count:
    2,208
    Likes Received:
    0
    Trophy Points:
    46
    Location:
    Madison, WI
    I have mine in my X-pipe between the collector and the cross-over. That was easier for me than putting it in the collector. Reads the same as the O2 sensor (when its working)
    zenboy99, Apr 25, 2006
    #2

  3. final5-0 Mustang Master

    Member Since:
    Apr 7, 2003
    Message Count:
    6,808
    Likes Received:
    1
    Trophy Points:
    78
    Location:
    DFW Texas
    I have mine in the collector on each side.

    I've seen some say their wb cautions about getting too close to the heat.

    Might wanna do a bit of research :shrug:

    Grady
    final5-0, Apr 25, 2006
    #3

Share This Page