Problems with Kenne Bell on 98 Cobra

Discussion in 'SVT Forum' started by blueoval1, Mar 27, 2004.

  1. blueoval1 New Member

    Member Since:
    Feb 17, 2004
    Message Count:
    8
    Likes Received:
    0
    Trophy Points:
    0
    Just installed a Kenne Bell Twin screw into our 98 Cobra. After everything has been installed, there is no boost!! Can not call Kenne Bell until Monday, Didn't know if anyone had run into this before. We took it upto 6000 rpms with no boost at all. It stops pulling vacuum but no boost. The belt is not slipping.

    Any opinions would be nice.
    blueoval1, Mar 27, 2004
    #1

  2. Lsredy2kstang Look, I'm special, dammit

    Member Since:
    May 13, 2000
    Message Count:
    2,798
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Woodstcock, Georgia
    Is there a blow by or wastegate? Maybe it is open?
    Lsredy2kstang, Mar 28, 2004
    #2

Share This Page