Rear diff leaking////will a 8.8 bolt to a reg 2.3 driveshaft?

Discussion in '2.3L (N/A & Turbo)' started by 4turboho, Feb 10, 2009.

  1. 4turboho New Member

    Member Since:
    Jan 31, 2009
    Message Count:
    119
    Likes Received:
    0
    Trophy Points:
    0
    Got the 91 mustang and the rear diff is leaking its not the gasket its the other side where the drive shaft connects to. now how hard is it to replace that seal?

    Also if I just go ahead and buy a 8.8 rear end, cause Im going to build a 2.3l turbo. for the time being will the reg 2.3l driveshaft bolt up to the 8.8?.....is it hard and what do i need to replace rear ends?

    just so i dont keep posting threads...how hard is it to replace gears?

    and last but not least I got a guy selling a 8.8 with 273 drum to drum with controll arms for 140 is that a good price?

    thank you:D
    4turboho, Feb 10, 2009
    #1

  2. Red_LX Doubt I could be of much help, unless you need por

    Member Since:
    Aug 21, 1998
    Message Count:
    10,471
    Likes Received:
    2
    Trophy Points:
    78
    I believe an 8.8 will bolt right up, yes. Pretty sure the U-joints were all the same.
    Red_LX, Feb 10, 2009
    #2

Share This Page