Saleen S/C ?

Discussion in 'Saleen' started by 01Saleen-465, Apr 15, 2005.

  1. 01Saleen-465 New Member

    Member Since:
    Apr 10, 2005
    Message Count:
    46
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Michigan
    I am new to these intercooled S/C engines. My question is if coolant runs through the intake manifold and the S/C housing or just the intake manifold? I am getting ready to pull the housing off from the intake and I don't want to have coolant wind up in the intake runners when I lift it off. Thanks.
  2. SGOODRIC50 Founding Member

    Member Since:
    Sep 12, 2002
    Message Count:
    130
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Maine
    Great question...I would like to know that too.
  3. Acheron315 New Member

    Member Since:
    Oct 24, 2003
    Message Count:
    238
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Charleston, SC
    It runs through just the intake manifold. The only liquid in the actual supercharger is the snout oil, which shouldnt leak out under any conditions.

    EDIT: On a side note, be very careful not to damage the vacuum control housing located about midway down on the drivers side of the supercharger. It should have a big yellow or orange warning decal not to mess with it because it is tuned from the factory, but sometimes this falls off.

    Good luck!

Share This Page