Seat Belt Hanger Question

Discussion in 'SN95 4.6L Mustang' started by VincentL, Jul 16, 2004.

  1. VincentL New Member

    Member Since:
    Jun 3, 2004
    Message Count:
    13
    Likes Received:
    0
    Trophy Points:
    0
    I want to remove the interior trim that covers the B and C pillars (dynamating the interior). But to take off that trim, you have to remove the hangers on the B pillars that the front seatbelts go through. My question is what torque do I use when putting the hangers back? This is one place I do not want to just wing it, and the Haynes manual doesn't touch the seatbelts.

    Anyone have the factory service manual? Help me Obi-Wan!

    Vincent
    VincentL, Jul 16, 2004
    #1

  2. MT1083 New Member

    Member Since:
    Sep 16, 2003
    Message Count:
    1,086
    Likes Received:
    0
    Trophy Points:
    0
    What is dynamating?
    MT1083, Jul 16, 2004
    #2

  3. VincentL New Member

    Member Since:
    Jun 3, 2004
    Message Count:
    13
    Likes Received:
    0
    Trophy Points:
    0
    VincentL, Jul 16, 2004
    #3

  4. MT1083 New Member

    Member Since:
    Sep 16, 2003
    Message Count:
    1,086
    Likes Received:
    0
    Trophy Points:
    0
    Thats what I was assuming it was. Thanks! :nice:
    MT1083, Jul 16, 2004
    #4

  5. nyuk98gt Active Member

    Member Since:
    Oct 11, 2000
    Message Count:
    1,325
    Likes Received:
    0
    Trophy Points:
    36
    VincentL:

    Tighten to "25 to 33 lb-ft", according to the Shop Manual.
    nyuk98gt, Jul 18, 2004
    #5

Share This Page