Shifter bezel

Discussion in 'SN95 4.6L Mustang Tech' started by okc2KGT, Dec 19, 2004.

  1. okc2KGT New Member

    Member Since:
    Oct 27, 2003
    Message Count:
    101
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Oklahoma City
    I'm swapping in a T45, and want to know if i have to get a 5spd bezel with a boot attached to it, or can i use the bezel i already have and just attach a boot to it?
    okc2KGT, Dec 19, 2004
    #1

  2. okc2KGT New Member

    Member Since:
    Oct 27, 2003
    Message Count:
    101
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Oklahoma City
    Nobody knows?
    okc2KGT, Dec 20, 2004
    #2


    Sponsored Ad

  3. Darkhorse845 Banned

    Member Since:
    Nov 17, 2004
    Message Count:
    236
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Las Vegas,Nevada
    What are you talking about?
    Darkhorse845, Dec 20, 2004
    #3

  4. FallenPhoenix New Member

    Member Since:
    Nov 22, 2003
    Message Count:
    934
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Odessa Tx
    just from looking at an auto and a manual '04 it looks like the bezel is the same. Not 100% but there's no outward difference.
    FallenPhoenix, Dec 20, 2004
    #4

  5. UNVMATT New Member

    Member Since:
    Jan 15, 2004
    Message Count:
    296
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    COLUMBUS
    Its pretty much the same. But with the way the stock boot attaches to the plastic you will need some epoxy or something to hold it on.

    Or they have the units at WWW.Stangparts.com that were take offs that have the boot already on it.
    UNVMATT, Dec 20, 2004
    #5

  6. Darkhorse845 Banned

    Member Since:
    Nov 17, 2004
    Message Count:
    236
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Las Vegas,Nevada
    Darkhorse845, Dec 20, 2004
    #6

Share This Page