Side exhaust / lowering

Discussion in 'SN95 V6 Mustang Tech' started by Krusher, Dec 12, 2003.


  1. Krusher

    Krusher New Member

    Joined:
    Nov 14, 2003
    Messages:
    51
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Hampton, VA
    well in the pipe dream future... the stang will have dual side exhaust... but here's the question... with a roush side exhaust skirt can I use the Eibach 1.1" lowering springs? (I don't want to scrap a speed bump)
    #1
  2. BABstangV6

    BABstangV6 Smater than the average bear!

    Joined:
    Apr 3, 2003
    Messages:
    607
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Rock Hill, SC
    Yea you should be fine with that minimal lowering. But all speed bumps are different, make sure you dont go over high speed bumps before you get your stuff on
    #2
  3. 98stangv8

    98stangv8 New Member

    Joined:
    Oct 4, 2003
    Messages:
    1,037
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    fayetteville, nc

    you will have to go over them very slowly! you may still scrape on the pipes a bit....you will hit once in a while...you just have to take it slow...I never put on the skirts for that reason..
    #3

Share This Page