subframes

Discussion in 'SN95 4.6 Talk' started by jlds91389, Jun 1, 2009.

  1. jlds91389 New Member

    Member Since:
    Feb 2, 2009
    Message Count:
    241
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Orange Tx
    im looking to buy some subframe connectors and i was just curious how hard would it be to make your own? i mean it dont look like a lot to it. Has anyone done it?
    jlds91389, Jun 1, 2009
    #1

  2. squeak93 Active Member

    Member Since:
    Jun 2, 2005
    Message Count:
    1,105
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Joplin, Missouri
    Its not too hard at all if you know where to source the metal from. Any exhaust shop can weld them up for you and some will even help fab them (we have a local one here that will). But then again they are only 50 bucks from blue oval industries.....
    squeak93, Jun 1, 2009
    #2

  3. jlds91389 New Member

    Member Since:
    Feb 2, 2009
    Message Count:
    241
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Orange Tx
    i know they are cheap but i was just wondering how hard it was i like to make stuff myself lol and i ave a welder in my shop so i could weld them myself also
    jlds91389, Jun 1, 2009
    #3

  4. squeak93 Active Member

    Member Since:
    Jun 2, 2005
    Message Count:
    1,105
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    Joplin, Missouri
    IT all depends on it you can find the right size metal cheap enough. Then fab up some seat brackets and start welding. They're obviously a real simple idea and not difficult at all.
    squeak93, Jun 2, 2009
    #4

Share This Page